User`s Manual

DC UPS Adapter

Quick Guide V. 1.0

1. Package Contents

You should have received the following items inside of package:

- DC UPS adapter unit

- Quick Guide

If anything is missing or damage in the package, please contact your dealer.

2. Product Overview

3. Installation and Operation

NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged.

Connect to Utility and Charging

Plug in the AC input plug (  ) to the wall outlet. The UPS will be automatically turned on and green LED will light on. If battery is not fully charged, the UPS will auto charge battery and green LED will flash.

Connect the Loads

Plug in the loads to DC output connector (  ) of the UPS. Then, connected device will be protected by UPS unit.



Restart/Off Button



LED indicator



DC output connector



AC input

LED Indication

This LED is two-color indicator: green or red color depending on operation status.

Status

Power on with battery fully charged.

Power on with charging battery.

UPS is on but power failure occurs. UPS will transfer to DC mode and battery is discharging.

Color

Green

Green

Green

On/Flash

On

Steady Flash

Quick Flash

Any fault occurs on UPS. Red On

4. Applications

The DC UPS is designed to provide emergency power backup to all kinds of DC-powered equipment such as routers, modems, set-top box, VOIP phone systems, surveillance system, alarm system, access control system and many critical telecom equipment.

5. Important Safety Warning (SAVE THESE INSTRUCTIONS)

To safely operate this DC UPS, please read and follow all instructions carefully.

Read this manual thoroughly before attempting to unpack, install, or operate.

You may keep this quick guide for further reference.

CAUTION! Do NOT place this unit under the hot and humid environment.

CAUTION! Do NOT disassemble this product.

CAUTION! If the battery level is low, please recharge battery immediately.

CAUTION! When install or replace a new battery, be sure positive (+) and negative (-) are correctly connected. Otherwise, DC UPS will be damaged.

5. Trouble Shooting

Use the table below to solve minor problems.

Problem

Red LED is on.

Possible Cause Solutions

Overload or short circuit occurs Press button for more than 1 second on UPS and UPS transfers to and release to restart unit. fault mode.

Battery backup time is shorter than nominal Battery is far too low. value.

No output and LED indicator is not on.

Internal fault has occurred.

Contact your dealer to replace the special battery.

Contact your dealer.

6. Specifications

AC INPUT

Voltage Range

Frequency

DC OUTPUT

Voltage

Max. Power

BATTERY

Type

Nominal Voltage

Capacity

Typical Charging time

PHYSICAL

90 VAC ~ 264 VAC

50 or 60 Hz

12VDC ± 5%

25W (2.1A)

Lithium-ion Battery

3.7VDC

2600mAh

3 hours recover to 90% capacity

Input Plug

Output cable

Dimension, D X W X H (mm)

Mounted on the housing (NEMA/Schuko/UK)

1m Length (DC Male Jack, OD 4mm, ID 1.7mm)

68 x 42 x 74

280g Net Weight

7. Approximate Back-up Time Table

Load Backup Time @ 12Vdc (min)

12V/1.0A Router

12V/1.5A Router

12V/2.0A Router

150

120

90