Dell PowerVault DL4000 Backup To Disk Appliance

Dell™ PowerVault™ DL4000 Backup to Disk Appliance
Interoperability Guide
This document provides information about the supported hardware and software versions for the Dell
PowerVault™ Backup to Disk Appliance system.
NOTE: The versions specified in this document use the same format as found on dell.com/support/downloads/ and may differ
from the version information displayed in the Windows® Device Manager or Dell™ OpenManage™ Server Administrator.
Supported Hardware
This section lists the hardware supported by PowerVault DL4000 Backup to Disk Appliance systems. Where
applicable, firmware and driver versions are also listed.
BIOS Versions
System
BIOS Version
DL4000
1.2.6 or later
Hard Drives (Internal)
System
Internal RAID Slots
Controller
Drive Type
RAID Level
DL4000
PERC H710P
0-1
Two (2) hot-swappable 2.5-inch SAS drives
1
2-9
Eight (2) hot-swappable 2.5-inch Nearline SAS drives
6
Storage Enclosures
Storage Enclosure
Firmware
Revision
Number of Enclosures Supported
PowerVault MD1200
1.0.1 or later
One (1)
NOTE: To connect or disconnect the redundant SAS cable(s), the DL4000 system must be powered off.
Hard Drives (External)
Storage Enclosure
RAID Controller
Drive Type
Drive Capacity
PowerVault MD1200
PERC H810
Nearline SAS
1TB , 2TB, 3TB
Dell PowerVault Backup to Disk Appliance Interoperability Guide
l
1
Network Interface Controllers (NIC)
System
NIC
Driver Revision
DL4000
Broadcom 57800S Quad-Port 1GbE NDC
15.4.0 or later
Intel I350 Quad-Port 1GbE NIC
12.1.76 or later
RAID Controllers
NOTE: Dell does not support upgrading internal RAID controllers. The internal controller shipped with the system is the only
supported configuration.
System
RAID Controller
DL4000
PERC H710P
PERC H810
Max Number
of Controllers
Firmware Revision
Driver Revision
1
21.0.2-0001
or later
5.02.220.64
or later
1
21.0.2-0001
or later
5.02.220.64
or later
Display Resolution
The minimum display resolution is 1280x1024.
Supported Software
This section lists the supported operating systems and applications on the PowerVault DL4000 Backup to Disk
Appliance.
NOTE: Running applications other than those listed in this document on the PowerVault DL4000 Backup to Disk Appliance is not
supported.
Operating System
NOTE: Clustering is not supported on the PowerVault DL4000 Backup to Disk Appliance.
System
Operating System
DL4000
Microsoft Windows Server 2012 Standard Edition
2
‫׀‬
Dell PowerVault Backup to Disk Appliance Interoperability Guide
Applications
PowerVault
System
Application
Application Type
Version
DL4000
Dell™ OpenManage™ Server Administrator
Systems Management 7.2.0 or later
Backup Software
See the following tables for information about the supported versions of backup software. The required version
is determined by the system and installed RAID controller(s).
AppAssure
System
DL4000
RAID Controller
5.3.1

PERC H710P, PERC H810
Appliance Software Stack Release
See the following table for information about the supported versions of the appliance software stack. The
required version is determined by the system, the installed RAID controller, and (if applicable) HBA.
System
RAID Controller
1.x
DL2300
PERC H710P, PERC H810

Dell PowerVault Backup to Disk Appliance Interoperability Guide
l
3
Information in this document is subject to change without notice.
© 2013 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, PowerVault, OpenManage, and the DELL logo are trademarks of Dell Inc.; Microsoft, Windows, Active
Directory, Virtual Server, Exchange, and Windows Server are either trademarks or registered trademarks of Microsoft Corporation in the
United States and/or other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their
products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
2013 - 03
4
Rev. A00
‫׀‬
Dell PowerVault Backup to Disk Appliance Interoperability Guide