7855 Polished chrome toaster ib

2 slice polished chrome toaster
Two year guarantee
This guarantee is valid in the UK and Ireland
only. It is in your interest to retain the retailers receipt as
proof of purchase. Please quote the following information
if the product develops a fault. These numbers can be
found on the base of the product.
Model No.
Serial No.
All Morphy Richards Products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of purchase it
should be returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and within 24
months of original purchase, you should contact the
freephone number quoting Model number and Serial
number on the product, or write to the address below.
You will be asked to return the product (in secure,
adequate packaging) to the address below along with a
copy of proof of purchase. Subject to the exclusions set
out below (see ‘Exclusions’) the faulty appliance will then
be repaired or replaced and dispatched usually within 7
working days of receipt.
If for any reason this item is replaced during the 2 year
guarantee period, the guarantee on the new item will be
calculated from original purchase date. Therefore it is vital
to retain your original till receipt or invoice to indicate the
date of initial purchase.
To qualify for the 2 year guarantee the appliance must
have been used according to the manufacturers
instructions. For example kettles should have been
regularly descaled or an iron cord should have been
stored as recommended by the instructions.
EXCLUSIONS
Morphy Richards shall not be liable to replace or
repair the goods under the terms of the Guarantee where:
1 The fault has been caused or is attributable to
accidental use, mis-use, negligent use or used contrary
to the manufacturers recommendations or where the
fault has been caused by power surges or damage
caused in transit.
2 The appliance has been used on a voltage supply other
than that stamped on the products.
3 Repairs have been attempted by persons other than
our service staff (or authorised dealer).
4 Where the appliance has been used for hire purposes
or non-domestic use.
5 Morphy Richards are not liable to carry out any type of
servicing work, under the guarantee.
6 Plastic filters for all Morphy Richards kettles and coffee
makers are not covered by the guarantee.
This guarantee does not confer any rights other than
those expressly set out above and does not cover any
claims for consequential loss or damage. This guarantee is
offered as an additional benefit and does not affect your
statutory rights as a consumer.
The After Sales Division, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ
Freephone (office hours): UK 0800 424848, Republic of Ireland 1800 409119
IMPORTANT
SAFEGUARDS
1 Read all instructions.
2 Do not touch hot surfaces. Use
handles or knobs.
3 To protect against fire and electrical
shock do not immerse cord, plug or
toaster itself in water or other liquid.
4 Ensure that this appliance is situated
out of the reach of children. Children
should never be allowed to operate
this appliance.
5 Unplug from outlet when not in use
and before cleaning. Allow to cool
before putting on or taking off parts.
6 Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Should you
require service, advice or repairs to
your appliance, please use the
freephone number.
This product contains no userserviceable parts.
7 The use of accessory attachments not
recommended by the appliance
manufacturer may cause injuries.
8 Do not use outdoors.
9 Do not let cord hang over edge of
table or counter, or touch hot
surfaces.
10 Do not place on or near a hot gas or
electric burner, or in a heated oven.
11 Do not attempt to move the appliance
whilst hot.
12 When unplugging, turn any control to
off, then remove plug from wall outlet.
13 Do not use appliance for other than
intended use.
14 Preheating of this appliance is not
required.
2
15 DO NOT TOUCH THE METAL TOP
RIM OF THE TOASTER DURING
OR AFTER USE AS THIS GETS
VERY HOT.
16 ENSURE THAT SUFFICIENT SPACE
IS LEFT ABOVE AND AROUND ALL
SIDES OF YOUR TOASTER TO
ALLOW AIR TO CIRCULATE.
PLACE THE TOASTER ON A HEAT
RESISTANT SURFACE. DO WATCH
YOUR TOASTER DURING USE.
A FIRE MAY OCCUR IF TOASTERS
ARE COVERED OR TOUCHING
FLAMMABLE MATERIAL,
INCLUDING CURTAINS,
DRAPERIES, WALLS, AND THE LIKE,
WHEN IN OPERATION.
17 Oversize foods, metal foil packages, or
utensils must not be inserted into a
toaster, as they may involve a risk of
fire or electric shock.
18 Do not attempt to dislodge food when
toaster is plugged in and never
introduce cooking utensils into the
slots.
19 Do not place bread or other
items on top of the bread slots as
this will damage your toaster and
creates a fire hazard.
20 IMPORTANT: Do not use under
cupboards
SAVE THESE
INSTRUCTIONS
Electrical requirements
Instructions for use
Check that the voltage on the rating plate of your
appliance corresponds with your house electricity
supply which must be A.C. (Alternating Current).
For appliances supplied with fitted plug
If the socket outlets in your home are not suitable
for the plug supplied with this appliance, the plug
should be removed and the appropriate one fitted.
Note: The plug removed from the mains lead, if
severed, must be destroyed as a plug with bared
flexible cord is hazardous if engaged into a live socket
outlet.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Should the fuse in the 13 amp plug require
changing a 13A BS1362 fuse must be used.
·
fl
‡
fi
›
‹
⁄
¤
Features of your toaster
⁄ Electronic variable browning control
¤ Cord storage
‹ Cancel button with neon
› Frozen bread button with neon
fi Re-heat button with neon
fl Bread carriage lever/hi lift for small items
‡ Removable crumb tray
· Variable width bread slots
Please read before use, taking careful note
of points 1 to 3
1 Before plugging in ensure that the carriage lever
fl is positioned as the above diagram.
2 Use your toaster once without bread. This will
pre-heat the new elements and burn off any dust
which may have accumulated during storage.
3 Select the desired level of
browning on the browning
control ⁄ marked 1 to 8. The
setting will vary according to the
moisture content and thickness of
bread. For best results ensure
that the bread slices are of even
thickness, freshness and size.
However, the variable width bread slots will accept
thicker or thinner bread than a conventional
toaster. Remember that stale bread toasts more
rapidly than fresh and thin bread toasts quicker than
thick. See additional points for more information.
4 After selecting the desired level, place your bread in
the slots and depress the bread carriage lever fl
downwards until it locks.
Note: The bread carriage lever will not stay down unless
the toaster is plugged in and wall switch is on.
5 After the desired degree of brownness has been
reached the bread will pop-up automatically ready
for removal from the slots. The bread carriage
lever will have returned to its upper position and
disconnected the element, ready for the next
toasting.
• If the first slices are not dark enough turn the
browning control to a higher setting.
• If the bread in your toaster becomes jammed
disconnect your toaster at the socket, allow it to
cool, then remove the bread.
• When not in use, switch your toaster off at the
mains and remove the plug from the socket. DO
NOT WRAP THE CABLE AROUND THE MAIN
BODY OF THE APPLIANCE DURING OR
AFTER USE.
Using the cancel setting O
When the bread carriage lever is depressed, the
cancel button ‹ will illuminate. If you wish to
interrupt the toasting process, press the cancel button.
Using the frozen bread button X
To toast frozen bread, do not adjust the browning
control, place the bread normally in the bread slots,
depress the bread carriage lever and press the frozen
bread button ›. The button will illuminate and the
toaster will automatically toast for an extended period.
3
Using the re-heat button
If your toast has popped up and gone cold, the
toaster offers a re-heat facility. To use, depress the
bread carriage lever and press the re-heat button
immediately fi. The button will illuminate and the
toaster will operate for a short period re-heating the
bread.
Using the high lift release H
If small bread is toasted, this may be removed
more easily by lifting the bread carriage lever.
Cleaning
1 After use and before
cleaning, switch off at the
mains, remove the plug and
wait for the toaster to
cool.
2 Wipe the outside of the
toaster with a damp cloth
only and dry with another
cloth or tissue.
• NEVER use metal polish
or coarse scouring agents
and never immerse your toaster in any sort of
liquid.
• NEVER use any pointed or sharp articles for
cleaning the inside, otherwise the heating element
will be damaged.
• NEVER use a brush or push your fingers or metal
objects down the slots.
Additional points
• In order to achieve uniform browning, we
recommend you wait a minimum of 30 seconds
between each toasting, so that the control can
automatically be reset.
• If toasting one slice only, you may need to adjust
the browning control to a slightly lower setting.
Note you will also notice a slight variation in toast
colour on one side of the single slice.
• Stale bread toasts more rapidly than fresh bread.
Therefore, the browning control should be set at a
lower setting than usual.
• Because of the variable width bread slots feature, all
sorts of bread can be used as well as teacakes, small
rolls etc. Slices should not however be so thick as
to cause burning or jamming within the bread slots.
• When toasting 2 slices it is recommended they are
of equal size and freshness.
• Allow the toaster to cool fully before putting away.
Worth noting
If your toaster does not work, check the following
points:
• Has the toaster been set correctly - is the plug
in its socket and the switch in the ‘on’ position?
• Is the plug itself or the socket faulty - check this
by plugging in another appliance.
• Does the fuse need replacing - if you have fitted
your own plug, are the internal plug
connections secure and correctly made?
Crumb tray
Crumbs will accumulate in the crumb tray and
could catch fire if not emptied periodically. When the
toaster has cooled down completely, tap the sides of
the case lightly to dislodge any crumbs lodged in the
toasting chamber and pull out the crumb tray ‡.
Empty the tray and replace it.
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The Company, therefore, reserves the right to change the specification of its models at any time.
Morphy Richards Limited, Mexborough,
South Yorkshire, England S64 8AJ
444-8304-94 Rev 2 8/01