Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS
WFW94HEX, WFW95HEX,
WFW97HEX
OVERALL DIMENSIONS
Washer dimensions
51"
(1295 mm)
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this appliance
be provided.
39" min.
(990 mm)
38"
(965 mm)
1"
(25 mm)
311/2"
(800 mm)
Drain System Options
Drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub. Select
method you need.
Custom under counter installation:
27"
(686 mm)
1"
(25 mm)
Recessed area or closet installation (washer only):
IMPORTANT: To avoid siphoning, 4.5" (113 mm) of
drain hose should be inside standpipe or below the top
of wash tub. Always secure drain hose with beaded tie
strap.
3"
(76 mm)
34" min.
(864 mm)
Floor standpipe drain system
48 in.2
(310 cm2)
41/2"
(113 mm)
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
A 1/4" (6 mm) diameter to 1" (25 mm) diameter Standpipe
Adapter Kit is available (Part Number 280130). To order,
please see toll-free phone numbers on front page of your
Washer User Instructions. Top of standpipe must be at
least 30" (762 mm) high; install no higher than 96" (2.44 m)
from bottom of washer. If you must install higher than 96"
(2.44 m), you will need a sump pump system.
4"
(102 mm)
3"
(76 mm)
1"
(25 mm)
1"
(25 mm)
Recessed area or closet installation
(stacked washer and dryer):
Custom cabinet installation:
6"
(152 mm)
Wall standpipe drain system
7"
(178 mm)
3"
(76 mm)
41/2"
(113 mm)
Floor drain system
24 in.2
(155 cm2)
77 /2"
(1969 mm)
48 in.2
(310 cm2)
14"
(356 mm)
1
5"
(127 mm)
3"
(76 mm)
1"
(25 mm)
24 in.2
(155 cm2)
4"
(102 mm)
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)
Laundry tub drain system
Floor drain system requires a Siphon Break Kit (Part
Number 285834) and additional drain hose (Part Number
8318155) with a connector kit (Part Number 285835) that
may be purchased separately. To order, please see tollfree phone numbers in your Washer User Instructions.
Minimum siphon break: 28" (711 mm) from bottom of
washer. (Additional hoses might be needed.)
41/2"
(113 mm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
min.
30"
(762 mm)
Minimum capacity: 20 gal. (76 L).
Top of laundry tub must be at least
30" (762 mm) above floor; install no
higher than 96" (2.44 m) from bottom
of washer.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10254447
08/2010