Quick instructions
Set 810
A
B
C
Connecting the system components
Plug in one end of the connecting cable to the socket on your sound source (e.g. television).
If necessary, use one of the adapters , (not included)or . Plug in the other end of the connecting cable to the socket LINE on the transmitter.
Connect the mains unit to the transmitter and to the mains.
Place the receiver into the transmitter’s charging compartment .
Before you use the rechargeable battery for the first time, charge it until the LED lights up green.
Adjust the volume on your sound source(TV Set) to a sufficient, medium level.
Switching on and using the stethoset receiver
The receiver automatically switches on when you pull the earbows apart.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
If you cannot hear anything through the receiver, increase the volume on your sound
source.
Switching the stethoset receiver off
The receiver automatically switches off when you take it off.
Charging the stethoset reciever
Place the receiver into the transmitter’s charging compartment without exerting too much
pressure. With a fully charged battery, the operating time is approx. 4 hours.
For details on the use of the Set 810, please refer to the enclosed operating instructions.
Sennheiser electronic GmbH & Co. KG
30900 Wedemark, Germany
Phone +49 (5130) 600 0
Fax +49 (5130) 600 300
www.sennheiser.com
Printed in Germany
Publ. 04/07
xxxxxx / A01