Equipex FC-33 Specifications

Operation Manual
For
Sodir
¼ Size Convection Broiler Oven– FC-33
12/6/12
765 Westminster Street  Providence, Rhode Island 02903  U.S.A.
Tel: (401) 273-3300
Fax: (401) 273-3328
www.equipex.com
e-mail: service@equipex.com
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all the instructions before use.
2. Do not touch hot surfaces; use handles or knobs.
3. To avoid electric shock, do not immerse the power cord, or any part of the unit, in any liquid.
4. Close supervision is necessary when any appliance is used, especially around children.
5. Unplug appliance from the electrical outlet when not in use, and before cleaning. Allow appliance
to cool before installing or removing any parts or accessories, and before cleaning.
6. Do not operate any appliance with a damaged cord or plug, or if appliance should sustain
damage, or malfunction in any way. In this event, return appliance to the nearest authorized
service facility for examination, repair or adjustment.
7. The use of accessories and/or attachments not recommended by the appliance manufacturer
may cause injury or damage to the appliance, and may void your warranty.
8. Do not use outdoors.
9. Do not allow the power cord to hang over the edge of a table or counter, or to be exposed to hot
surfaces, as damage may occur.
10. Do not place appliance on or near a burner, or in a heated oven.
11. To disconnect an appliance, first turn all controls to the ‘off’ position; then unplug the power cord
from the wall outlet.
12. Do not use appliance other than for its intended use.
13. SAVE THESE INSTRUCTIONS FOR LATER USE!
INTRODUCTION
The SODIR model FC-33 convection/broiler oven is designed to offer quality baking, cooking,
reheating and finishing. The ovens are constructed of food service quality stainless steel, and are
equipped with a rear-mounted blower fan and heating element along with two top-mounted
quartz broiling elements. The units are thermostatically controlled up to 480 F with a 120-minute
timer. One green and two orange lights indicate the unit is powered up and in which mode convection or broiling - the unit is operating. The mode switch controls the different modes of
operation: a) convection, b) broiling or c) cool down/defrost (fan-only) modes. The oven
includes three wire baking racks and a bake pan, and can accommodate 1/4-size sheet pans or 1/2size steam table pans. Extra bake pans are available as an option at additional cost.
Specifications:
Model
FC-33
FC-33/1
Electrical
Plug Configuration
208/240V, 1PH, 3KW, 13/15A
NEMA-6-15P
120V, 1PH, 1.7KW, 15A
NEMA-5-15P
INSTALLATION
The SODIR convection oven needs to be connected to a grounded outlet of proper voltage,
208/240V or 120V, depending on the model. DO NOT place the unit in a damp area or near
steam sources. DO NOT place the oven directly over heating elements or burners, unless the
oven is placed on an insulated shelf. Make sure that the exterior rear ventilation panel is not
blocked. Maintain 4” clearance at each side, rear and top of the oven.
OPERATION
Preheating
To preheat the convection oven, select the desired temperature by rotating the thermostat knob
clockwise to desired temperature setting, the mode switch to the desired cooking mode convection or broiling - and then turn the timer knob which is also the ON/OFF switch
clockwise to the maximum setting (120 minutes). Two indicator lights (one green and one
orange) will be lit. The orange light will stay on until the oven reaches the desired temperature.
The green light will stay on until the timer reaches the indicated time setting. Allow 10 to 20
minutes for the preheating process.
Cooking in convection mode
After the preheat process is completed, select the desired temperature and mode (unless they
are already set) and turn the timer knob to select the time setting. When the set time is elapsed,
the heating element(s) and the blower fan will be switched off and the green indicator light will
go out.
Broiling or finishing mode
To finish or broil, select the quartz mode, designated on the oven face board by a row of triangles
over the fan. Then turn the timer to the desired time setting. The top-mounted infra-red heaters
and the fan will begin to operate. The elements attain operating temperature in under 30 seconds.
When the set time has elapsed, the oven will turn off.
The SODIR convection/broiler oven can be used for a wide variety of foods. Cooking times will
vary depending on food products, temperature settings and desired results.
Cleaning
WARNING: Disconnect (unplug) electrical power supply before cleaning
Cleaning is very important in maintaining a safe and well working machine. Allow the oven
to cool before cleaning. Remove the baking racks and the bake pan, and clean them separately
using a damp cloth or sponge and mild liquid soap. Use a cloth dampened slightly with a soap
and water mixture to clean all exterior and interior stainless steel surfaces. Use a clean lint-free
cloth to remove the excess water or soap.
DO NOT use an abrasive sponge on exterior or interior surfaces
DO NOT wash the oven under running water
DO NOT spray the exterior motor housing with any liquid
DO NOT allow water to drip into the motor housing or onto electrical
components
You should inspect all parts on a regular basis to ensure that all is in proper working order. If a
part is damaged, have the unit repaired by an authorized service agency prior to returning the
unit to operation. If you have trouble locating a service agency in your area, please consult our
website at http://www.equipex.com/, or call us at 1-800-649-7885 and ask for customer service.
These models must be taken to a service facility; in-store service is not covered.
Spare Parts FC-33
Spare Parts FC-33
DWG#
Part Number
Qty
Description
1
H04093BRO
1
Top casing
2
H04159
1
Top inside casing
3
H03010
1
Seal
4
15001GSE
1
Left side
5
15024
1
Left panel
6
15007
1
Baking dish
7
F01031
3
Grid
8
B07002
2
Spring
9
H04109POR
1
Door
10
15003
1
Inner door
Handle
11
A15031
1
12
H01034
1
Glass
13
H04083BRO
1
Bottom casing
14
A08009
1
Green pilot light 220V
14
A08007
1
Green pilot light 120V
15
A14078
3
Knob
16
A13009
4
Foot
17
H04222BRO
1
Right panel
18
A02019
1
Timer
19
A08003
1
Orange pilot light 220V
19
A08002
1
Red pilot light 120V
20
A06042
1
Thermostat
21
A01014
1
Mode Switch
22
15001DSE
1
Right side
23
A06035/1
1
High Limit Thermostat
24
D04020
2
Element+quartz tube 220V
24
D04020
2
Element+quartz tube 120V
25
15230
1
Fan protection
26
D02158
1
Heating element 220V
26
D02035
1
Heating element 120V
27
H04146
1
Back inside casing
28
15231
1
Motor protecting
29
A03044
1
Fan motor 220V
Fan motor 120V
29
A03052
1
30
15229
1
Back rear
31
A10002
1
Cord closer
C03013
1
Cord with plug
H04109COM
1
Door Complete
32
LIMITED WARRANTY
Your new EQUIPEX product is warranted to the original purchaser for a period of one year from the date of purchase.
This limited warranty is against defects from original factory imperfections in material and/or workmanship
and includes labor for replacement of defective parts, provided repairs are performed by an authorized service
agency. Our obligation under this warranty is limited to repairing or replacing any part or parts thereof. The
CUSTOMER must inform the Service Agency of warranty coverage and provide a copy of the dated sales or
delivery receipt BEFORE WARRANTY REPAIRS BEGIN. Replacement parts and accessories are warranted for
ninety (90) days from the date of purchase when purchased separately and will be verified by dated sales receipt or
packing slip for that item. All parts or accessories replaced under warranty must be returned to the Service Agency.
This warranty applies only to equipment under normal use and service in the U.S.A. and Canada. It does not
apply to any item which has been repaired or altered in any way so as, in the judgment of EQUIPEX, to affect its
reliability.
THE FOLLOWING ARE NOT COVERED UNDER WARRANTY:
1.
Damage caused by abuse, misuse or dropping or other similar incidental damage caused by, or as a
result of, customer failure to follow assembly, operation, cleaning, user maintenance or storage
instructions.
2.
Labor to replace inoperative parts such as bulbs, plugs or racks due to normal wear and tear or abuse.
3.
Materials or labor to repair scratched, stained, chipped, pitted, dented or discolored surfaces, attachments or
accessories.
4.
Transportation charges to or from a service agency for repair of your machine. If you should have
questions relating to this issue, please call Equipex at 1-800-649-7885.
5.
Labor charges to install or test attachments or accessories, which are replaced for any reason.
6.
SHIPPING DAMAGES. Visible and hidden damages are the responsibility of the freight carrier.
The consignee must file the claim promptly against the carrier.
KEEP ALL ORIGINAL
CONTAINERS AND PACKAGING MATERIAL FOR CARRIER INSPECTION.
7.
Products placed or stored in the equipment are not subject to this warranty and no responsibility is
assumed thereof.
THIS WARRANTY IS GIVEN EXPRESSLY AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, FOR MERCHANTABILITY AND FOR FITNESS TOWARD A PARTICULAR PURPOSE AND
CONSTITUTES THE ONLY WARRANTY MADE BY EQUIPEX, LLC. IT NEITHER ASSUMES, NOR AUTHORIZES
ANY PERSON TO ASSUME FOR US, ANY OTHER LIABILI TY IN CONNECTION WITH THE SALE OF THE
SUBJECT EQUIPMENT.
For service, please call EQUIPEX at 1-800-649-7885, menu option # 3
765 Westminster Street  Providence, Rhode Island 02903  U.S.A.
Tel: (401) 273-3300
Fax: (401) 273-3328
www.equipex.com
e-mail: service@equipex.com