PDi PD168-213 Installation Instructions

Better Solutions Are Within Reach

TM

MODEL NUMBER:

PD168-213

Document Number:

PD196-242R1

Two Piece Strain Relief Installation Instructions

Page 1 of 1

SCOPE

TO INSTALL PD168-213 CABLE STRAIN RELIEF KIT.

KIT CONTENTS

•

2 PDI-205-SPLIT BUSHING

•

1 PD185-163 O-RING

•

1 PD220-120 SPACER WASHER

•

1 PD185-162 CLAMP, COAX LOOP

•

PDIBHSCS252088, BUTTON HEAD, ANTI-PILFER SCREW

TOOLS REQUIRED:

•

1/8” AND 5/32” ALLEN WRENCH

•

7/16” WRENCH

INSTRUCTIONS

MAKE COAX CABLE CONNECTION BETWEEN WALL CABLE AND ARM CABLE BEFORE ASSEMBLING STRAIN RELIEF.

1. INSTALL (2) BUSHING PDI-205-SPLIT AROUND COAX CABLE. THREAD O-RING PD185-163 ONTO BUSHING

(BUSHING HAS GROOVE FOR FIT). HAND PRESS INTO WALL BRACKET.

2. PLACE COAX CABLE INTO PD185-162 COAX LOOP CLAMP (FLAT SIDE DOWN) MAKING SURE NOT TO PINCH CABLE.

ANGLE CLAMP DOWN TO ALLOW CLEARANCE OF COAX DURING MOVEMENT OF ARM.

3. INSERT PDIBHSCS252088 BUTTON HEAD SCREW THROUGH CLAMP FIRST AND THEN PD220-120 WASHER. HAND

TIGHTEN WITH ALLEN WRENCH TO SECURE TO WALL BRACKET. MAKE SURE COAX IS IN CLAMP BEFORE

TIGHTENING. ALLOW AT LEAST 5” FROM CLAMP TO CONNECTION AND LEAVE SLACK IN COAX AT BASE OF WALL

BRACKET.

4. VERIFY THE PDIBHSCS252088 ANTI-PILFER SCREW IS SECURE AND DOES NOT ALLOW THE ARM TO BE REMOVED

FROM THE WALL BRACKET.

*NOTE: IF YOUR WALL BRACKET HAS A SET SCREW, YOU WILL NEED TO LOOSEN IT BEFORE THIS ASSEMBLY AND

TIGHTEN UPON COMPLETION.

PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664

Set Screw