INSTALLATION INSTRUCTIONS W

INSTALLATION INSTRUCTIONS
For Models # P962-077 (Date: 10/18/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
2. Shut off power
at the circuit breaker and remove
P
the old fixture, including the mounting hardware.
3. Attach the mounting bracket (A) to the outlet box
with two screws (B) (Size: #8-32N*L13mm). The
side of the mounting bracket (A) marked “GND”
must face out.
Fig. 1
A
B
C
E
D
F
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig.2,
making sure that all wire nuts are secured. If your
outlet has a ground wire (green or bare copper),
connect the fixture's ground wire to it. Otherwise,
connect the fixture's ground wire directly to the
circular strap using the green screw provided.
FINISHING THE INSTALLATION (Fig 1)
5. Attach the base (C) to the mounting bracket (A)
with screws (D).
6. Align the glass shade (H) and wire mesh (G) to the
socket cluster (E) and secure with rods (F).
7. Install light bulb (not included) into the socket. (DO
NOT EXCEED THE MAXIMUM WATTAGE
RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
outlet box and test the fixture.
G
H
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED
BY A QUALIFIED ELECTRICIAN TO ENSURE
PROPER WIRING AND INSTALLATION.
LA-2226E
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)