BT Concero 1500 Owner Manual

Add to my manuals
2 Pages

advertisement

BT Concero 1500 Owner Manual | Manualzz

eries and pull them out.

eries as

Please over turn ch the ery or (item code geable batteries s ore use.

and charge batterie

Remove this tab already fitted

Rechar for 24 hours bef een and activate the batt o the mains wall socket and swit

use.

for

, secure the cable behind the

only)

s et on the back of the charger d into the eries by pulling om the back of the handset.

een

ready now is

s.

hour 24 for charge

(multipacks

or each additional handset and charger: plug the mains power adapt eries for 24 hour o charge.

emove the batteries, simply slide open the batt ger to ective film from the handset scr ective film from the handset scr

handsets

e

o 1500

et.

s, plug the telephone line cor harg

: Charge the handset batt emove the prot

If you ever need to r

Concer BT Y our

compartment cover and using the finger holes grip the batt emove the prot shown above.

additional

048610) into the sock power on.

your

retaining clip and plug the other end int

1 F

Set up

3 Place the handset on the char

2 R the plastic tab away fr ter 24 hour telephone wall sock

3 Af

2 Place the handset on the base t

2 C

1 R

Important and the base lens and activate the batt or your phone may not work.

et the power adaptor and switch on.

into the wall sock

3 Plug the other end of

General information

For information on safety instructions, cleaning, technical information or connecting to a switchboard, please refer to the ‘General Information’ section in the full user guide at www.bt.com/producthelp

Guarantee

Your BT Concero 1500 is guaranteed for a period of 12 months from the date of purchase.

Subject to the terms listed below, the guarantee will provide for the repair of, or at BT’s or its agent’s discretion the option to replace the BT Concero 1500, or any component thereof, (other than batteries), which is identified as faulty or below standard, or as a result of inferior workmanship or materials. Products over 28 days old from the date of purchase may be replaced with a refurbished or repaired product.

The conditions of this guarantee are:

• The guarantee shall only apply to defects that occur within the 12 month guarantee period.

• Proof of purchase is required.

• The equipment is returned to BT or its agent as instructed.

This guarantee does not cover any faults or defects caused by accidents, misuse, fair wear and tear, neglect, tampering with the equipment, or any attempt at adjustment or repair other than through approved agents.

This guarantee does not affect your statutory rights.

For further information within and outside the 12 month guarantee, please refer to the full user guide at www.bt.com/producthelp

Product disposal instructions

The symbol shown here and on the product means that the product is classed as Electrical or

Electronic Equipment and should not be disposed with other household or commercial waste at the end of its working life.

The Waste of Electrical and Electronic Equipment

(WEEE) Directive (2002/96/EC) has been put in place to recycle products using best available recovery and recycling techniques to minimise the impact on the environment, treat any hazardous substances and avoid the increasing landfill.

Product disposal instructions for residential users

When you have no further use for it, please remove any batteries and dispose of them and the product as per your local authority’s recycling processes. For more information please contact your local authority or the retailer where the product was purchased.

Product disposal instructions for business users

Business users should contact their suppliers and check the terms and conditions of the purchase contract and ensure that this product is not mixed with other commercial waste for disposal.

Warning

This equipment is not designed for making emergency telephone calls when the power fails.

Alternative arrangements should be made for access to emergency services.

R&TTE Directive & Declaration of Conformity

This product is intended for use within the UK for connection to the public telephone network and compatible switchboards.

This equipment complies with the essential requirements for the Radio Equipment and Telecommunications

Terminal Equipment Directive (1999/5/EC).

For a copy of the Declaration of Conformity please refer to www.bt.com/producthelp

Offices worldwide

The services described in this publication are subject to availability and may be modified from time to time. Services and equipment are supplied subject to

British Telecommunications plc’s respective standard conditions of contract.

Nothing in this publication forms any part of a contract.

© British Telecommunications plc 2011.

Registered Office: 81 Newgate Street, London EC1A 7AJ.

Registered in England No. 1800000.

Designed and produced by The Art & Design Partnership Ltd.

Printed in China / Issue 1 / ADP09-11 plug the other end into or

’t talled but don elephone line cord ring on the connector clip on back of base.

in lug 1 P echargeable geable batteries eries.

esponsibility for damage s, cables and rechar geable batteries

(already in handset) rechar

2x AAA NiMH 500mAh oduct may not work. Any replacement r

: Only use the mains power adaptor t be of the same type. BT accepts no r

T Concero 1500 by using any other type of batt

Mains power adaptor

(item code 048610)

Charger caused to your B batteries mus

Important

Handset supplied in this box, or this pr cable behind retaining the wall socket yet.

adaptor with the blue

2 Plug in the mains power

Secure power adapt

(item code 048611). is pre-ins

1 The t geable batteries

(already in handset) rechar

2x AAA NiMH 500mAh Mains power adaptor

only)

(item code 048611) d talled)

(multipacks

(pre-ins

Telephone line cor

handset on off

Ans.

Skip

Play

Delete

Find

Base

additional each for

Handset

Contents

ents x cont Check bo

BT Concero 1500

User Guide

1

Plug in

2

Charge

3

Go!

10%

Setting up is easy. Just follow the simple steps in this guide.

If you need further assistance, please visit our website www.bt.com/producthelp to view our advanced user guide or call our helpdesk on 0800 218 2182*

* Calls made from within the UK mainland network are free. Mobile and International call costs may vary.

Your phone

Handset

Open phonebook.

Soft key: Use with icons displayed on the screen above the key.

Opens menu.

Selects menu options.

Display Redial list and move up menu options.

Increase volume.

Soft key: Use with icons displayed on the screen above the key.

During a call press to mute your voice so your caller cannot hear you.

End a call.

Press and hold for 5 seconds to turn handset on/off.

Make/receive phone calls.

Display Call list and move up menu options.

Decrease volume.

Stop playback of current message.

Delete message.

Replay message.

Skip to next message.

Press and hold to turn ringer on/off.

Press and hold to lock/ unlock keypad.

Used when connected to a switchboard/PBX, and with some

BT Calling Features.

The answer machine handset controls on buttons work when a message is being played on the handset.

Make internal calls.

Press and hold to insert a Pause in number to be dialled.

and will only

Base

Find

Page/locate a handset.

Delete

Delete messages during playback.

Stop

Stop message during playback.

Ans.

on off

Switch answering machine on/off.

message.

Green In use

LED indicator

Find

Delete Stop

Ans.

on off

Vol.

Play

Skip

Vol.

Vol.

Adjust speaker volume during playback.

Message display showing number of messages and answering machine status.

Digits flash when there are new messages.

Play

Play messages.

Red battery charging LED indicator

Skip

Skip forward during message playback.

3

Go!

Set time and date

Press to open the main menu.

Press to scroll to hs settings and press soft key. dAte & tiMe is displayed, press .

Press to set tiMe and press soft key. Enter 2 digits for the hour and 2 for the minute using the 24hr format and press soft key. You will hear a confirmation tone.

Press , set dAte is displayed. Press . Enter the day, month and year using the dd-mm-yy format and press . You will hear a confirmation tone.

Making calls

Press then dial the phone number. Press to end the call.

Answering calls

If you have subscribed to Caller Display, the caller’s details will be displayed before you answer

(see below and also the full user guide online at www.bt.com/producthelp for details).

Lift the handset from the base or charger to answer incoming calls. If the handset is

not on the base or charger, press .

Mute

Press the soft key during a call to activate Mute mode, if you want to prevent the caller hearing anything from your end. Press the soft key again to resume your call.

Redial (up to last 10 numbers called)

Press to open the list of most recently dialled numbers. Press or to scroll through the list.

Press to redial the number displayed or press to access the options menu.

Phonebook

Storing new phonebook entries (up to 50)

Press to open the phonebook. The first entry (or list eMPty) is displayed.

Press the left soft key, Add is displayed, press . nAMe is displayed. Using the letters on the keypad, enter the name, then press . You may need to press the same button a few times until the letter you want is displayed. For example, press once for A, or twice for B. nuMBer is displayed, enter the phone number for the entry and press .

If you make a mistake, press to delete the last digit or letter entered.

Press or to select a ringtone you want to be played when this caller rings you and press to confirm. Press to return to standby.

Dialling a phonebook entry

Press . Scroll or to the entry you want. Press to dial.

Or, search alphabetically using the keypad to enter the first letter of the name you want then scroll or to the exact entry and press to dial.

Caller Display and the Call list

You must subscribe to a Caller Display service for this feature to work. Your network provider may charge you for this service.

View and dial from the Call list

Press , then or to scroll through the last 40 incoming calls.

The indicates new missed calls. The number of New Calls to the handset is shown on the standby screen until they have all been viewed in the calls list.

The icon is displayed when the phone number is too long to be fully shown on the screen. Press to allow you to scroll through the rest of the number.

Press to dial the number displayed.

Copy a Call list number to the phonebook

Press , then or to the entry you want and press .

Press until stOre nuMBer is displayed and then press . nAMe is displayed.

Enter a name using the keypad and press . The number is displayed, press to confirm.

You will hear Melody 1 played, press or to choose a ringtone you want to be played when this caller rings you and then press .

Answering machine

Your answering machine is on and ready to record messages. The controls are shown in the base diagram to the bottom left and the features can also be accessed via the handset Ans MAchine menu.

Recording your own outgoing message

Press . The display shows Ans MAchine, press .

Press to scroll to Ans settings and press .

Press to scroll to OutgOing Msg and press .

Press or to select either Ans & recOrd or Answer Only and press .

Press to scroll to recOrd Msg and press to record your message.

When prompted, speak your message into the handset. When finished press .

Your message will be played back to you. Press if you want to delete the message.

Set the answer delay

To set the number of rings that are played before the answer machine picks up:

Press . The display shows Ans MAchine, press .

Press to scroll to Ans settings and press .

Press to scroll to Answer delAy and press .

Press or to select the number of rings before the answer machine answers: 2-9 rings or time saver and press .

For detailed instructions on all the answering machine features see the full user guide online at www.bt.com/producthelp

Help

Most problems can be fixed with a few simple checks.

Problem

No dial tone

Poor speech quality

Battery icon flashing and scrolling digits

Using broadband on the same phone line?

Answer machine not answering calls

Solution

Only use the cables and batteries supplied.

Make sure both the mains power adaptor cable and telephone line cord are plugged into the correct sockets.

Make sure the product is not located too close to other electrical appliances. This can also help improve the handset range from the base.

The battery charge is very low. Make sure you charge the batteries for 24 hours before use to ensure maximum battery performance.

Make sure you plug the phone into the wall socket via an ADSL microfilter (not supplied), otherwise you may have problems with this product and your broadband service.

ADSL microfilter

Check the answer machine is on and set to Answer &

Record. Also check that the ring delay is set to answer before any voicemail service (e.g. 1571) on the line.

Find out more

New Frequently Asked Questions available at www.bt.com/producthelp

If you need more detailed instructions, a full user guide is available to download from www.bt.com/producthelp

If you cannot find the answer to your problem in the full online user guide, then please call our free Helpline on 0800 218 2182* . Our dedicated advisors are more likely to be able to help you than the retailer where you made your purchase.

This document is also available in other formats, such as Large print, Braille and Audio CD. If you would like a copy, please call 0800 218 2182*.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement