PMC Carriers
NEW!
AcPC4610CC
CompactPCI
Non-intelligent
PMC Carrier Card
(conduction-cooled)
An air-cooled rear transition board,Acromag Model
TRANS-C4610,is available to map the field I/O on the
PMC module to the rear of the CompactPCI system.
Features
■
3U CompactPCI card
■
Holds one PMC card
■
32-bit 33/66 MHz PCI Interface
■
Transparent PCI/PCI bridge for data transactions
from the PCI bus to PMC module
■
Rear connection I/O access
■
Supports both 5V and 3.3V signalling
■
Conduction-cooled -40 to 85°C
Operating temperature: -40 to 85°C or conduction-cooled.
Storage temperature: -55 to 100°C.
Relative humidity: 5-95% non-condensing
American National Standard for 2mm Connector Equipment
Practice on Conduction Cooled Euroboards:
ANSI/VITA 30.1-2002.
American National Standard for Conduction Cooled PMC:
ANSI/VITA 20-2001(R2005).
Power (received from the CompactPCI 3U Back Plane):
3.3V DC (±5%)*: 135mA typical,150mA max.
5.0V DC (±5%)*: 50mA typical,70mA max.
±12V DC (±5%)**: Per PMC module.
* With no PMC module installed,±12V DC not used.
** Max.power 7.5W (total all supplies) per PMC standard.
MTBF: Call factory
Physical: CompactPCI Carrier Card
Physical configuration: 3U CompactPCI Card
100 x 160mm.
Rear CompactPCI connectors: 2mm J1 & J2 connectors.
PMC connectors: Three 1mm connectors.
The conduction-cooled model (AcPC4610CC) uses a conduction-cooled frame with wedge-loks® and thermo bars.
Physical: Transition Module
Physical configuration: Half-length 3U CompactPCI Card
100 x 80mm.
Connectors:2mm RJ2 connector which maps the rear I/O signals to a SCSI-3 connector. This model also uses a standard
rear front panel assembly with a SCSI-3 connector cutout.
Meets PCI specification version 2.3,CompactPCI specification
PICMG 2.3 R1.0,and PMC specification P1386.1.
Meets PCI specification version 2.3,CompactPCI specification
PICMG 2.3 R1.0,and PMC specification P1386.1.
Data transfer bus: Slave with 32-bit,16-bit,and 8-bit data
transfer operation.
Interrupts: CompactPCI bus INTA# interrupt signal.
PCI Interface: PLX Technology PCI6540 transparent PCI/PCI
bridge for data transactions from the PCI bus (system host)
to the PMC site. The bridge device provides a 32-bit 33/66
MHz PCI interface.
Ordering Information
Carrier Cards
AcPC4610CC
CompactPCI bus carrier card for one PMC module,
conduction-cooled
AcPC4610E
CompactPCI bus carrier card for one PMC module,
air-cooled. See Bulletin 8400-485.
Accessories (see accessories documentation for details)
TRANS-C4610: Transition module,air-cooled
5028-432: Shielded cable,SCSI-3 68-pin connector,2m long.
5025-288: Termination panel,DIN rail-mount,
68 screw terminals,SCSI-3 connector.
AcPC4610CC
PMC 1
PCI
Controller
J2
Field I/O signals are routed through the carrier card’s
rear J2 connector.
Environmental
J1
A heat frame enables conduction cooling in applications
where ambient or forced air can’t provide adequate
cooling.This unit is ideal for airborne systems,deployment in battleground equipment,and other situations
with advanced thermal management requirements.
PMC and CompactPCI bus Compliance
J12
This board uses a PLX Technology PCI6540 transparent
PCI/PCI bridge for data transactions from the PCI bus
(system host) to the PMC site.The bridge device
provides a 32-bit 33/66 MHz PCI interface.
Specifications
J14
This board provides an easy and low cost solution
that enables use of a PMC mezzanine I/O module in a
standard 3U CompactPCI computer system. The carrier
card acts simply as an adapter to route PCI bus signals
to and from the PMC module through the CompactPCI
card slot edge connector. All Acromag PMC modules
and those from other vendors are supported.
This conduction-cooled carrier card interfaces a PMC module to a CompactPCI computer system.
J11
Description
All trademarks are the property of their respective owners.
Acromag, Inc. • PO Box 437, Wixom, MI 48393 • Phone: 248-295-0310 • Fax: 248-624-9234 • e-mail: solutions@acromag.com • www.acromag.com
8400-486 Printed in USA 10/08 Copyright © 2008 Acromag, Inc. Data subject to change without notice
PMC Modules
3.150’’ (80.0)
A22
F22
TRANS-C4610 Transition Module
J2
A1
F1
A22
F22
J2
F22
A22
AcPC4610E
PMC Carrier Card
CompactPCI
Backplane
TRANS-C4610
Transition Module
F25 F1
A25 A1
A1
F1
J2
3.937’’
(100.0)
SCSI-3
TP1
TP1
F1
A1
J1
GND
SCSI-3
GND
NOTE: DIMENSIONS ARE IN INCHES (MILLIMETERS).
5028-432 SCSI-3 Cable
TOP VIEW
2 METERS
(78.72 INCHES, +4.0 / -0.0 INCHES)
P2
PIN 34
P1
PIN 68
PIN 35
PIN 1
PIN 68
PIN 34
PIN 1
PIN 35
5025-288 Termination Panel
TOP VIEW
282-222
PIN 68
TB2
J1
1 2
PIN 1
3.40"
(86.36)
PLACE MODEL/SERIAL
LABEL HERE.
ModeL:
Serial:
TB1
SIDE VIEW
7.1"
(180.34)
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34
35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68
TERMINATION
MARKINGS
2.7"
(68.58)
NOTE:
DIMENSIONS ARE IN INCHES (MM)
FRONT VIEW
Acromag, Inc. • PO Box 437, Wixom, MI 48393 • Phone: 248-295-0310 • Fax: 248-624-9234 • e-mail: solutions@acromag.com • www.acromag.com
8400-486 Printed in USA 10/08 Copyright © 2008 Acromag, Inc. Data subject to change without notice