Rangefinder-type
Microwave Slab Tracking Sensor
MWS-MT-1 PAT.
Micro-Tracker
Penetrates steam
50msec. high speed response
Vertical installation
For slabs of any thickness
MWS-MT-1
Unaffected by high temperatures,
steam or water!
1.
3.
The MWS-MT-1 type Micro-Tracker has
been developed for product tracking
in the hot line process. The unit consists
of a controller, antenna, and reflector.
The MWS-MT-1 is an FM ‒ CW method
range finder. The MWS-MT-1 emits
microwaves towards the reflect object in 2.
order to measure the reflection from it.
When a slab interrupts the beam
between the antenna and the reflect
object, the reflection will not be received
resulting in the slab presence signal
being output. The sensor can be
installed either on a diagonal or
horizontal axis. Because of the digital
detection, this will not be affected by
vapor, water running on the slab and/or water spray.
Options:
1. Heat shield board
2. Water cooled bed
3. Waveguide
4. Ceramic antenna cover
(For horizontal installation)
Unaffected by adverse conditions
Microwaves are unaffected by heat, vapor, flames, or water running on the slab and water spray.
When countermeasures to heat are required, use the options above.
High reliability
The MWS-MT-1 detects the presence or absence of the slab by receiving or not receiving the reflection from the
reflector. Because of digital detection, this will not be affected by vapor, water running on the slab or water spray.
High speed response time
50msec. update time.
No beam slippage
Beam adjustment is easy because the beam is conical-shaped and there will be no errors caused by slippage
of the beam.
No set-to-set interference
This permits the use of multiple Micro-Trackers in close proximity to each other.
Enclosure rating IP65 equivalent
New reasonable price
MICRO-TRACKER
MWS-MT-1
CR-200T (In case of vertical installation, reflector is not necessary)
10m (distance from antenna to reflect object)
1a solid state relay: DC24V, 0.1A (standard) or 1a relay contacts: AC250V, 2A cosø=1 (optional)
Slab presence output
1a solid state relay: DC24V, 0.1A (standard) or 1a relay contacts: AC250V, 2A cosø=1 (optional)
Sensor: Approx. 3.3kg (4.7kg) Reflector: Approx. 1.0kg
Horizontal installation
For slabs of thickness >20mm
Abnormal
(Not used)
Slab presence
Analog output
4 20mA
(Not used)
Slab
Presence
Diagonal installation
For slabs of any thickness
Cable Gland22mm
(3/4 )
7.
5
205
10
17.
7
Air Inlet
φ 97
4−φ 12
Controller
Note: The dimensions in parentheses are for use of a roller as the reflect object.
2−φ 12
182
200
0
10
20
2- φ 12
20
120
160
30
40
45
20
5
45
90
(φ145)
84.6
MWS - MT
AVE TRACKI NG SENSOR
M
I CROW
W
ADECO CO. , LTD
SERI AL NO.
TYPE
120
7.
5
Antenna
W
ADECO
φ6
(500)
210
93
220
P.C.D.65
φ85
17.
7
80