Industrial Accelerometer (A0322L5)

Specifications Sheet
A0322L5
March 2014
Industrial Accelerometer
SIGNAL/POWER
GROUND
Dynamic Performance
Sensitivity (±10%)
100 mV/g (10.2 mV/m/s2)
Measurement Range
±50 g (±490 m/s )
Frequency Range (±3 dB)
0.50 to 10,000 Hz (30 to 600,000 cpm)
Mounted Resonant Frequency
25 kHz Nominal
Amplitude Linearity
±1% (0 Based, Least Squares, Straight Line)
Transverse Sensitivity
≤7%
ELECTRICAL
CONNECTOR
5/8–24 UNEF–2a
2 PIN (MIL–C–5015)
2
1.66(42.2)
11/16 (18) HEX
Environmental
Shock Limit
5,000g pk (49,050 m/s2)
Temperature Range
-54 to 121°C (-65 to 250°F)
Temperature Response
See Graph
Sealing / Rating
Welded Hermetic / IP68
.035(0.89)
1/4−28 UNF−2B
X .20(5.1)
Electrical
Settling Time
≤2 sec (Within 1% of Bias)
Discharge Time Constant
≥0.3 sec
Excitation Voltage / Current
18 to 28 VDC / 2 to 20 mA
Output Bias
8 to 12 VDC
Output Impedance
<150 ohms
Broadband Resolution (1 to 10 kHz)
350 μg (3,434 μm/s2) Electrical Noise
Case Isolation
>108 ohms
Sensitivity
Deviation(%)
20
-65 -40
-4
32
68
104
140
176
212
248°F
-54 -40
-20
0
20
40
60
80
100
120°C
10
0
-10
-20
Temperature Response
www.assetweb.com
Ø.680(ø17.3)
TYP
Specifications Sheet
A0322L5
March 2014
Mechanical
Weight
51 grams (1.8 oz)
Mounting Thread / Torque
¼-28 UNF-2B / 2.7 to 6.8 Nm (2 to 5 lb ft)
Sensor Element / Geometry
Ceramic / Shear
Case Material
Stainless Steel
Connector Type (Top)
MIL-C-5015, 2 Pin
Pin A – Signal/Power
Pin B – Ground
Supplied Accessories
Single Point Calibration at 100 Hz
¼-28 Mounting Stud
©2014, Emerson Process Management.
Emerson Process Management
835 Innovation Drive
Knoxville, TN 37932
T (865) 675-2400
F (865) 218-1401
www.assetweb.com
The contents of this publication are presented for informational purposes only, and while every
effort has been made to ensure their accuracy, they are not to be construed as warranties or
guarantees, express or implied, regarding the products or services described herein or their use or
applicability. All sales are governed by our terms and conditions, which are available on request.
We reserve the right to modify or improve the designs or specifications of our products at any
time without notice.
All rights reserved. Machinery Health is a mark of one of the Emerson Process Management group
of companies. The Emerson logo is a trademark and service mark of Emerson Electric Co. All other
marks are the property of their respective owners.