SOL (ROUND DECK) 7244 Builder Series Luxury Series

SOL® (ROUND DECK) 7244
Always check the website for the most updated specifications: www.americh.com
All bathtub dimensions are ± 1/2”
Tub pictured with optional waste & overflow
Builder Series
DIMENSIONS
Luxury Series
72” x 44” x 23” (1829 x 1118 x 584 mm)
Whirlpool Operating Gallons = 64 (Liters = 242)
Gallon to Overflow = 95 (Liters = 360)
P
P
MATERIAL: Acrylic (All Americh Standard Colors)
TUB FLOOR: Textured
UNDERMOUNT: No
ELECTRICAL REQUIREMENTS
Combination
Platinum Series
(pump and blower location only)
P
P
B
Airbath System II Airbath System III
Americh recommends one 20 amp ground fault circuit interrupter
(GFCI) for each power supply provided with the bathtub.
OPTIONAL ACCESSORIES
 Chromatherapy*
 Grab Bars: 9” *
 High Density Insulation*
 iBath Sound System
 Inline Heater (whirlpool only)
 Jets: Additional or Rotary*
 Lo Profile Tub Edge
 Ozone System (whirlpool and/or Airbath only)
 Pillows: 13”
 Remote Control Upgrade (select series only)
 Serenity Soak (tub only)
 Syllent Pump with Heated Air*
 Trim Kit Upgrade*
 Waste & Overflow
 Cable Drive Overflow*
 Linear Overflow
*
B
LEGEND:
P
PUMP
B
SUCTION
BLOWER
LIGHT
GRAB BAR
B
JET
ROTARY JET
ON/OFF CONTROL
ACCESS PANEL (MINIMUM 16” X 20”)
*Standard on Platinum Series
CODES AND COMPLIANCE
Americh products meet or exceed the following standards:
INSTALLATION TIPS
 Install according to Owner’s Manual and local codes.
 Airbath III units may be 1½” - 2½” higher than stated.
 Any whirlpool or Airbath unit requires an access panel.
®
 Hot water supply should be 65-75% of tub capacity or greater.
 Underwriters Laboratories (UL)
 Underwriters Laboratories - Canada (cUL)
 Canadian Standards Association - (CSA)
 ANSI Z124.1 • ANSI A112-19.7
 ANSI A112.19.8 • ASTM F462-79
Contact Americh for additional approvals.
 Always consult your local plumber for recommendations as
installations will vary.
 Cut-out dimensions: Americh recommends waiting until the actual
unit is received.
Last Update 03/15/14