TMBH1 datasheet e

SKF Product data sheet
High frequency portable induction heater TMBH 1
A portable bearing heater weighing only 4,5 kg (10 lb)
The SKF bearing heater TMBH 1 is a portable lightweight
heater for heating bearings with an inner diameter
ranging from 20 to 100 mm (0.8 to 4 in) and a maximum
corresponding weight of 4,5 kg (10 lb). The heater uses
a patented method of heating based on high frequency
induction, which provides optimised efficiency.
This method is very quiet and creates no magnetisation
at all. In addition to bearings, the heater can also be used
for heating ferrous components such as gears, pulleys,
bushings and shrink rings.
●
●
●
●
●
Lightweight and portable (4,5 kg – 10 lbs)
Heating efficiency better than 85%
Components are not magnetised
Equipped with temperature and time control
Supplied with a heating clamp, temperature probe, power cable,
heat resistant gloves and a carrying case
TechnicaI data
Designation
TMBH 1
Power:
Voltage
Power (maximum)
Cosine ϕ
100 – 240 V, 50 – 60 Hz
350 Watt
> 0,95
Component size range:
– inner diameter
– width – weight Dimensions:
Control box Heating clamp Operating space heating clamp Complete unit in carrying case 150 × 330 × 105 mm (6 × 13 × 4 in)
114 × 114 mm (4,5 × 4,5 in)
52 × 52 mm (2,0 × 2,0 in)
370 × 240 × 130 mm (15 × 9 × 5 in)
20 ... 100 mm (0,8 ... 4 in)
< 50 mm (2 in)
up to approximately 5 kg (11 lb)
Length clamp cable Length power cable Length temperature probe cable 75 cm (30 in)
2 m (80 in)
100 cm (40 in)
Control functions:
Time control Temperature control Accuracy temperature control Maximum temperature 0 – 60 minutes
0 – 200 ºC (32 – 392 ºF)
± 3 ºC (6 ºF)
200 ºC (392 ºF)
Weight complete unit 4,5 kg (10 lb)
Mounting and Lubrication
E
NN
Selection guide
$
#
There are no totally restrictive guidelines to follow when choosing your SKF bearing
heater. It will depend upon the type and geometrical dimensions of the components
you want to heat. Nevertheless, SKF offers the following helpful general selection guide.
%
SKF m20 concept
"
LH
" 5.#)
#5*)N
$ 5*)N
%5*)N
TIH 030m
“m20” represents the weight (kg) of the heaviest SRB 231 bearing which
can be heated from 20 to 110 °C (68 to 230 °F) in 20 minutes. This defines the
heater’s power output instead of its power consumption.
N
TIH 100m
SKF Maintenance Products
www.mapro.skf.com
www.skf.com/mount
TIH 220m
© SKF 2007/07
® SKF is a registered trademark of the SKF Group
The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless permission is granted.
Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss
or damage whether direct, indirect or consequential arising out of use of the information contained herein.