TSM17S_Q_Quick Set-up guide_EN-AMP10.14_920

TSM17S/Q
920-0077A
Integrated Step Servo Motor
Requirements
Quick Set-Up Guide
I/O
1
You will need these items to set-up TSM17S/Q:
• a 12 - 48 volt DC power supply
• a small flat blade screwdriver for tightening the
connectors (included)
• a PC running Microsoft Windows XP, Vista, or Windows 7
or 8
• Software: Step-Servo Quick tuner
• a programming cable (included)
2
• 8 optically isolated digital inputs for S/Q
models,
• 1 analog input, 0 to 5 Volts
• 4 optically isolated digital outputs for S/Q
models
• Please see Applied Motion Products
website or the TSM17S/Q Hardware
Manual for more information.
Connect the Power Supply
• Connect the power supply “+” terminal to the drive “+”
terminal & the power supply “-” terminal to the drive “-”
terminal using 16 to 20-gauge wire.
3
• Be careful not to reverse the wires. Reversing the
connection may open the internal fuse and void the
warranty.
Power Supply
To Earth Ground
To Power Supply+
To Power Supply-
RC880
V-
V+
V-
V+
Vin
+
+
Vout
-
• If a regulated power supply is being used, there may be
a problem with regeneration that can be solved with the
use of an Applied Motion Products RC880 Regeneration
Clamp. Please see the Applied Motion Products website
or the TSM17S/Q Hardware Manual for more information.
TSM
Configure the Drive
• Install the “Step-Servo Quick Tuner” software application.
4
• Connect the drive to PC using the programming cable.
• Run the software application.
• Apply power to the drive.
• The software will communicate with the drive and display
the model & firmware version.
• Follow the steps on the “Step-Servo Quick Tuner” to
set up. For Q models, use Step Servo Quick Tuner's "Q
Programming" tab to create and download Q programs.
Safety Instructions
• Only qualified personnel should assemble, install, operate, or maintain this equipment.
• Read all available documentation before assembly and operation.
• It is vital to ensure that all system components are connected to earth ground.
• This product contains electrostatically sensitive components that can be damaged by incorrect
handling.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel (831) 761-6555
Fax (831) 761-6544
www.applied-motion.com