DOUBLE-ROLL
STAINLESS STEEL
TOILET TISSUE DISPENSER
Technical Data
B-7686
B-76867
Specify Model Required:  Model B-7686 Bright polished stainless steel
 Model B-76867 Satin-finish stainless steel
12-1/2''
320mm
2''
50mm
Typ.
Flange and
Mounting Bracket
Finish Face of Wall
1/2''
13mm
3-3/16''
2''
S
Typ.
S
50mm
80mm
Support Arm
5-1/4''
135mm
5-1/4''
Setscrew
Concealed
Wall Plate
135mm
20'' 510mm
100mm
Recommended Mounting Height off Floor
for Universal / Accessibe Design
3-15/16''
MATERIAL:
Flanges & Support Arms (3) -— 18-8, type-304, 22-gauge (0.8mm) stainless steel. Each flange has a concealed, 18‑gauge
(1.2mm) stainless steel mounting bracket. All-welded construction. Secured to wall plate with a stainless steel setscrew.
Concealed Wall Plates (3) — 18-8, type-304, 19-gauge (1.0mm) stainless steel.
Spindles (2) — Chrome-plated plastic. Equipped with heavy-duty internal spring.
INSTALLATION:
To remove concealed wall plates from back of flanges and mounting brackets, loosen setscrews. Mount each wall plate with
prongs at top; secure with sheet-metal screws, furnished by manufacturer, at points indicated by an S. Engage mounting
brackets onto prongs of wall plate, then secure into position by tightening setscrews at bottom of flanges.
Note: Centerline-to-centerline of concealed wall plates must be within 1/16'' (1.6mm) of dimension shown.
For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure the unit with
sheet-metal screws furnished. For other wall surfaces, provide fiber plugs or expansion shields for use with sheet-metal screws
furnished by manufacturer, or provide 1/8'' (3mm) toggle bolts or expansion bolts.
For partitions with particle-board or other solid core, secure with sheet-metal screws furnished, or provide through-bolts,
nuts, and washers. For hollow-core metal partitions, provide solid backing into which the furnished sheet-metal screws can be
secured.
SPECIFICATION:
Double-roll toilet tissue dispenser shall be type-304 stainless steel with __________ (insert one: bright polished or satin) finish.
Unit shall accommodate two standard-core toilet paper rolls up to 5-1/2'' (140mm) diameter (1800 sheets). Flanges and support arms shall be 22 gauge (0.8mm) and equipped with concealed, 18‑gauge (1.2mm) mounting brackets that are secured
to concealed, 19-gauge (1.0mm) wall plates with stainless steel setscrews. cSpindles shall be equipped with heavy-duty internal
springs.
Designer's Note: Theft-resistant toilet tissue spindles, which require special key for removal, are available as an optional accessory.
To specify, add suffix .60 to model number. Example: B-7686.60.
c
Double-Roll Toilet Tissue Dispenser shall be Model __________ (insert model number) of Bobrick Washroom Equipment,
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company,
Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment
Limited, United Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions.
Revised 6/30/15
Printed in U.S.A.
© 2015 by Bobrick Washroom Equipment, Inc.