FiberLink 7514 DVI and Audio Series FEATURES

FiberLink 7514 DVI and Audio Series
FEATURES
DVI and Stereo Audio over one Fiber
Ideal Applications: Digital signage, broadcast or
corporate studios, auditoriums, stadiums and
theaters, airport or transportation hubs, distance
learning, surgical or medical imaging and more!
Transmits single-link DVI (640 x 480 up to 1920 x
1200 - 165 MHz pixel clock)
Box
or
Card
DVI transmission (up to 1920x1200) and stereo audio over one
single mode or multimode fiber without compression, scaling or
adjustments.
The Fiberlink 7514 Series supports DVI
transmission (up to 1920x1200) and stereo
audio over one single mode or multimode fiber
without compression, scaling or adjustments.
It is ideal for Digital signage, broadcast or
corporate studio, auditorium, stadium and
theater, airport or transportation hub, distance
learning, and surgical or medical imaging
applications, to name a few!
The 7514 transmitter box provides a convenient
DVI loop-thru port and the 7515 receiver
provides 2 DVI outputs along with stereo audio.
The 7514 transmitter will generate EDID
information internally, acquire it via the DVI
loop-thru, or you may capture and store EDID
information.
Dual Optical Output Version available (MM
version only)
Supports HDTV resolutions of 480p, 720p, 1080i and
1080p (DVI format)
Uses no compression, color space conversion or
scaling for crystal clear signals
Only one fiber used - no pixel skewing
Supports up to 45 foot (13.72m) DVI input cable
DVI Input loop-through on transmitter
Supports EDID from loop-through, internal
emulation from the transmitter, or you may capture
and store EDID information.
Requires no adjustments, equalization or
de-skewing during installation
Advanced input circuit equalizes and re-clocks
noisy and distorted DVI input signals
Two DVI outputs on box receiver
allows for driving two monitors
DVI up to
1920x1200 &
Stereo Audio
Transmits signals over one fiber using advanced
CWDM multiplexing
Low audio/video skew, <300 uSec
7510 Tx
Fiber
Cable
DVI Loop-thru
Monitor
7511 Rx
DVI Video Displays
with Stereo Audio
FiberLink 7514 DVI and Audio Series
SPECIFICATIONS
Video
Input Type
Number of Video Channels
Video Processing
DVI Input Loop-through
EDID (DDC) Support
Pixel Clock Range
Scanning System Supported
Color Space Format Supported
Maximum Input Cable Length
Maximum Output Cable Length
Number of DVI Outputs
General Specifications
DVI-D or DVI-I (digital signal only )
single link
1 single-link DVI-D up to 1920x1200
24 bits, no compression or scaling
Yes; both box & card versions
From loop-through, internal
or capture & storage capability
25 - 165 MHz, continuous
Progressive or Interlaced
RGB or YPrPb
45 Feet (13.72m)
16 Feet (5m)
2 on box version, 1 on card version
Audio
Number of Audio Channels
Frequency Response
Bits-per-Sample/Sampling Rate
Maximum Audio Level
SNR (A-Weighted)
THD+N
Channel Phase Differential
Crosstalk
Input Impedance
Output Impedance
Audio to Video Diff. Delay (skew)
LED Indicators
Power, Video, Audio,
Alarm LED (card version only)
Power Requirements*
9-24 volts AC or DC, 10 watts,
34.12 BTU/Hr
Operating Temperature Range
-20oC to +45oC
Optical Connector
7514/7515: ST x 1 7516: ST x 2
Operating Wavelength
SM: CWDM (1300-1600nm band)
MM: CWDM (850nm band)
Physical Size
6.5 W x 1.15 H x 8 L (inches)
165 W x 29 H x 203 L (mm)
Weight
1 lb. (0.455 kg)
Slots filled in 6000A Card Cage
3
MTBF
45,000 Hours
*For operation from 95-250 volts AC, 50/60 Hz, a PDPS-2 plug-in adapter is
required.
2, unbalanced
+0/-0.5 dB, 20 Hz - 20 kHz
24 bits; >48 kHz
+10 dBu
100 dB
0.001%, 20 Hz - 20 kHz
+0.1o
100 dB (1 kHz)
>24K Ohms
< 1 Ohm
300 uSec
Operating Loss Budget and Maximum Usable Distance*
Wavelength
Loss(dB)
1310 SM
0-15
850 MM
0-8
850 MM
0-4
Dual Optical
Output Version
UPDATED 02/20/2016
All specifications subject to change without notice. ©2016
Distance (km)
15
0.75 (50u)
0.35 (62.5u)
0.60 (50u)
0.30 (62.5u)
SM = Single Mode Fiber
MM = Multimode Fiber
*Distance specifications are only approximate and are not guaranteed. Operating
loss budget must not be exceeded.
Ordering Information
Part Number
Description
Fiber Cores
7514-xyS
Transmitter
1
7515-xyS
Receiver
1
7516-x1S
Transmitter, Dual MM Optical Outputs
2
PDPS-2-pp
Power Supply
N/A
Power Supply Suffix Codes (pp) for AC Line Cord:
NA - North America
AU - Australia EU - Europe
JP - Japan
UK - United Kingdom
Part Number Suffix Codes:
x:
B
Box Version
C
Card Version
y:
1
7
850 nm Multimode (MM)
1310 nm Single Mode (SM)
Note: 7514, 7515, and 7516 are not compatible with 7500, 7501 or 7502, 7510, 7511,
7512
Sales
CS206-7514_A
T: 978-263-5775
sales@artel.com
customercare@artel.com
www.artel.com