MLxS CIS datasheet

Connevans
Solutions to improve the quality of life
This product may be purchased from Connevans Limited secure online store
at www.DeafEquipment.co.uk
DeafEquipment.co.uk
Solutions to improve the quality of life
MicroLink MLxS
TM
The MicroLink MLxS is the first miniaturized FM receiver with a digital frequency synthesizer for full
multi-frequency flexibility. The receiver features fully automatic, non-contact frequency synchronization
with either a WallPilot or the Campus S.
The MicroLink MLxS is compatible with all Phonak FM transmitters and the WallPilot, and is recommended for use with this equipment.
MLxS with BTE instrument
FM
MLxS with adapter for CI pocket processor
Audio shoe
(e. g. AS4-MLxS)
MLxS
MLxS
MicroLink CI S
adapter
Pocket processor
connector cable
Technical Data
Dimensions:
Frequency range:
Frequency:
Frequency stability:
Frequency fine tuning
(AFC):
Type of modulation:
Adjacent channel
selectivity:
Sensitivity:
Signal-to-noise
ratio:
EMC:
IEC approval:
Antenna:
Voltage range:
Current consumption
(typical):
• FM / FM + mic.
• Standby mode
Audio bandwidth:
Total harmonic
distortion:
(LxWxH) 13.5x10.9x14 mm
169.40–176.00 MHz (Band HA)
176.00–181.90 MHz (Band HB)
187.45–194.50 MHz (Band J)
214.00–220.00 MHz (Band NB)
Multi-channel, quartz-stabilized
Better than ±10 ppm over the
whole voltage and temperature
range
Product Information MicroLink MLxS
Special Features
• Highly flexible
• Automatic Frequency Synchronization (AFS) with WallPilot
• Direct Frequency Synchronization (DFS) with Campus S
• Ultra-compact (smallest miniaturized standard FM receiver
on the market)
• Energy-saving, intelligent standby mode
• Maximum retention with the new AS4-MLxS audio shoe
• Adjustable balance between FM and BTE microphone signals
• Built-in antenna
• Off switch
• Powered by the hearing instrument battery
• Automatic Frequency Control (AFC)
• “Soft squelch” system
• Contemporary design
• Extremely simple handling
• Compatible with most behind-the-ear hearing aids on the market
±6 kHz
FM
> 50 dB at 150 kHz
SINAD > 22 dB at E = 3 mV/m
55 dB
According to ETS 300445
standard
According to ETS 300442
standard
Built-in magnetic antenna
0.9–1.6 V
2.1 mA (1.2 V)
< 200 µA (1.2 V)
100–7500 Hz (–3 dB)
< 2% for fmod = 1kHz
and ▲ fdev = 3 kHz
Operating temperature
range:
–10 °C to +60°C
Reception range:
up to 40 meters (120 feet)
Pin
diagram
GND (–)
VDD (+)
OUT
FM
AS3-MLx AS4-MLxS AS5-MLx AS6-MLx AS7-MLx
AS4-MLx
SuperFront
Supero
Classica
MAXX
Aero
SonoForte
✓
✓
✓
(children’s version)
MLxS switch settings
Hearing Instrument with DPAI:
For these hearing instruments, it is recommended to use the MLxS
in the Switch position •.
e. g., Supero
PicoForte2
PicoForte3
Piconet2
SonoForte2
PowerZoom
NovoForte
Digital hearing instruments normally feature a programmable audio
input.
✓
✓
••
Hearing Instrument without DPAI:
If the hearing instrument does not feature DPAI, the MLxS switch position • means “FM” and the switch position means “FM+M”.
e. g., Aero, Classica, MAXX, PicoForte, SuperFront
• All audio shoes originally used with the MLx are also recommended
for use with the MLxS.
• The new AS4-MLxS audio shoe is tamper-proofed for pediatric use
and specially adapted to the MLxS design.
Plug rotation
➂
max. 270°
➃
➄
✓
A hearing care professional can adapt the MLxS plug to the audio shoe
quickly, simply and without tools. For maximum antenna effectiveness,
the MLxS must be positioned in line with the hearing instrument.
027-0381-02/V00 1003 FAG Printed in Switzerland © Phonak AG All rights reserved
➁
➀