2-
Po
rt
Pa
r
al
le
lP
CI
Compliant with PCI Local Bus Specification, Revision 2.3
Add two IEEE 1284 Parallel Ports on system
Easy Plug and Play
Automatic selects IRQ & I/O address
Supports Standard Parallel Port (SPP), Enhanced Parallel (EPP) & Enhanced
Capability Port (ECP)
Faster data rates up to 1.5Mbytes/sec
PCI 32-bit
2 x DB25 female parallel connectors
Introduction:
This UGT-PC20PL is part of a series of I/O card based on the PCI Express technology. It offers TWO LPT port that enables
the user to connect parallel devices. The Parallel (LPT) port offer data transfer rate up to 1.5 Mbps with built-in
ECP/EPP/SPP/BPP auto switching operation modes to give you maximum system performance and efficiency via DB25
pin female connector. This card is the best solution for your Centronics peripherals. The UGT-PC20PL is design to be easy
and simple to use for commercial, office and home use. This card is designed to meet PCI local bus specification rev. 2.3
and with the standard or low profile brackets can be installed virtually in any PC with all major operating systems. The I/O
address and IRQ are automatically configured to simplify the installation at the same time offers a reliable and high
performance solution for Parallel Communication.
Specifiactions:
Model:
Interface:
Ports:
Dimensions:
UGT-PC20PL
PCI
2 Parallel Ports (DB25 Female)
121 x 56 x 18mm
System Requirement
Windows XP/Vista/7/8 (32/64 bit)
Available PCI slot
Package Contents
1 x 2-Port Parallel PCI Host Card
1 x Driver CD
1 x User Manual
1 x Bracket with one DB25 female parallel port
2 x Low Profile Brackets
Send us an e-mail at: inquiry@vantecusa.com
All Registered Trademarks Belong To Their Respective Companies
www.vantecusa.com
Copyright © 2013 Vantec Thermal Technologies. All Rights Reserved.