PDi PD203-113 Installation Instructions
Add to my manuals1 Pages
PDi PD203-113 enables you to transmit low voltage AC/DC power and RF signals onto a single coax for use with a coax-powered small screen television. The one-gang standard-sized wall plate features two behind-the-wall connections â an RF IN âFâ fitting and two flying leads for power. It has an RF insertion loss of 0.5 dB (typical), a maximum voltage of 34 VAC or 48 VDC, and a maximum current of 4 amps. The wall plate is easy to install and use, making it a convenient solution for transmitting power and signals to your TV.
advertisement
Communication
Systems Inc.
Better Solutions Are Within Reach™
PD203-113 Combiner Wall Plate Page 1 of 1
INSTALLATION INSTRUCTIONS
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.
CAUTION
RISK OF ELECTRIC SHOCK,
DO NOT OPEN!
This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD CONFORM TO ALL LOCAL
CODES. READ AND FOLLOW THE SAFETY INSTRUCTIONS BEFORE ATTEMPTING THIS INSTALLATION.
NOTE to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
INTRODUCTION: The PD203-113 Combiner Wall Plate is specifically designed to allow insertion of low voltage AC or DC power and
RF signal onto a single coax for use with a coax powered small screen television.
INSTALLATION: The one-gang standard sized wall plate has two behind-the-wall connections – an RF IN “F” fitting and two flying leads for power.
1. Connect the RF signal coax cable to the “RF IN” jack as shown.
2. Connect TV power to the flying lead wires. NOTE: The Black Wire is common (ground). The Red Wire is for Power.
3. Mount the plate to the wall with the two screws supplied.
4. Connect the TV coax to the exposed “F” fitting on the front of the plate.
5. Test the TV for proper operation.
SPECIFICATIONS:
RF Insertion Loss: 0.5 db typical
Maximum Voltage : 34 VAC or 48 VDC
Maximum Current: 4 amps
RF/POWER
To TV RF IN
BLACK
Common
RED
Power
PDI Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 FX +1-937-743-5664
PD196-031 Rev 1
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project