Digital Watchdog MC355T Instruction manual

PRECAUTIONS
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
INSTRUCTION MANUAL
MC355T
CONNECTIONS
■ Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.
■ CONNECTIONS
■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short-circuits or damages.
12VDC
VIDEO OUT
■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■ Install away from electric or magnetic fields
About this manual
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
■ DIMENSIONS
■ Protect from humidity and dust
■ Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen or boiler
room, as the temperature may raise to high levels.
■ Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
CAUTION :
■ Mounting Surface
The mounting surface material must be strong enough to secure the
camera.
WARRANTY INFORMATION
Digital Watchdog (referred to as “the Warrantor”) warrants the
Camera Series against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years from the date of original purchase,
if the camera is determined to be defective, the Warrantor will repair or
replace the unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for
the initial five (5) years. To obtain warranty or out of warranty service,
please contact a Technical Support Representative at 1-866-446-3595
Monday through Friday from 9:00 AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the original purchase is
required before warranty service is rendered. This warranty only
covers failures due to defects in materials and workmanship which
arise during normal use. This warranty does not cover damage which
occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failures which result from accident,
misuse, abuse, neglect, mishandling, misapplication, alteration,
modification, faulty installation, set-up adjustments, improper antenna,
inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply,
lightning damage, rental use of the product or service by anyone other
than an authorized repair facility or damage that is attributable to acts
of God.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above. The Warrantor
will not be liable for incidental or consequential damages (including,
without limitation, damage to recording media) resulting from the use of
these products, or arising out of any breach of the warranty. All express
and implied warranties, including the warranties of merchantability and
fitness for particular purpose, are limited to the applicable warranty
period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied warranty
lasts, so the above exclusions or limitations may not apply to you.
This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
If the problem is not handled to your satisfaction, then write to the
Address above.
Check for polarity when using a DC 12V.
INSTALLATION
C
Service calls which do not involve defective materials or workmanship
as determined by the Warrantor, in its sole discretion, are not covered.
Costs of such service calls are the responsibility of the purchaser.
A. Removing the screw on the upper case by using
L-wrench.
D
TROUBLESHOOTING
C. Make the 4 mounting screw hole on the ceiling/wall by drawing
the positions using the bottom case
Before sending the camera out for repair, check the items below. If the
problem persists after checking these items, contact your service
center.
■ If no image appears.
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
F
D. Put Power cable and Video cable into the ceiling/wall.
E. Align the bottom case to the ceiling/wall by using
the screws.
E
F. Adjust the camera to its position
(Referance - "CAMERA SETTING" )
■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
B. Separate the upper case from the bottom case
G. Connect the upper case and bottom case.
B
A
H. Tighten the Stop Screw to the upper case using L-wrench.
CONNECTIONS AND CAMERA SETTINGS
■ CAMERA SETTINGS
■ LENS ADJUSTMENTS
Adjust the panning(360˚) and tilt(70˚) position.
■ CAMERA DIP SWITCH
ON
OFF
1
NTSC
PAL
2
x
x
3
x
x
4
x
x
Model
Ultra WDR Camera MC355T (micro Dome)
Camera TYPE
Color/BW - MC355T
Image
Scanning
Micro-Vandal Day/Night PIXIM Dome Camera
Mount
In-Ceiling ( mounting adaptor available- optional)
Device
1/3" PIXIM
Pixels-Total
742(H) x 552(V)
Pixels-Effective
720(H) x 540(V)
System
525 line, 2:1Interlace
Horizontal Frequency Internal Mode
15,734Hz
Vertical Frequency Internal Mode
59.94Hz
Min. Scene Illumination
F1.2
0.08 Lux [TDN 0.01 Lux]
WDR
WDR LEVEL
-20 to 20
DIP Switch
NTSC/PAL
on/off
Lens
Fixed Length
3.6mm
Resolution
Horizontal
480 TV Lines [at TDN (B/W) :520 TV Lines]
Video Output
VBS 1.0Vp-p
VBS 1.0Vp-p(75 Load)
S/N Ratio
S/N Ratio
48dB
Environmental Conditions
Operating Temperature
-10℃ ~ +55℃(14℉ ~ 131℉)
Humidity
Less than 90%
Power Requirement
12VDC
Power Consumption
12VDC: 130mA
Dimensions(W x H)
80.0 x 59.5mm
Nema Type
IP66
Weight
255g
CE, FCC, RoHS
Certified
2.9mm(MC355T29)
Power
Physical Specification
Certifications