Mitsubishi WD57734 Lamp Replacement

Mitsubishi WD57734 Lamp Replacement
Mitsubishi WD57734 Lamp Replacement
Install a new lamp in your Mitsubishi WD-57734 DLP HDTV.
Written By: Herman Chai
INTRODUCTION
Accessing the lamp in this television is straightforward and requires minimal disassembly.
TOOLS:
Latex or nitrile gloves (1)
Phillips #1 Screwdriver (1)
Phillips #2 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 3
Mitsubishi WD57734 Lamp Replacement
Step 1 — Lamp
 Before disassembling your
television, be sure it is powered off
and unplugged.

Remove the single 18 mm Phillips
#1 screw on the lamp access
panel.
Step 2

Pull the lamp access panel off of
the back panel of the television by
pulling straight back on the left side
of the panel near the screw then
pulling to the left.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 3
Mitsubishi WD57734 Lamp Replacement
Step 3

Loosen the two Phillips #2 screws
securing the lamp housing to the
television until the screws will
swivel vertically.
 These two screws are
permanently attached to the
lamp housing and cannot be
removed completely.
Step 4

Using the handle, pull the lamp
housing straight back out of the
television.
 Do not touch the glass of the
lamp with your bare hands. The
oil from your fingers can distort
the TV image and lead to other
issues.
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2015-05-05 11:48:17 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 3