How to monitor multi-device in WAN?

ShenZhen Foscam Intelligent Technology Co., Limited
How to monitor multi-device in WAN?
Suitable for MJPG cameras: FI8903W, FI8904W, FI8905W, FI8907W, FI8908W,
FI8909W, FI8910W, FI8918W, FI8919W.
MJPG camera supports to monitor up to 9 IP cameras through internet
simultaneously. Please make sure you can access every camera in
WAN/Internet first. And then take the following steps as a reference to set
multi-device in WAN.
Step 1: Click For Administrator  Multi-Device Settings.
Click The 2nd Device and then enter Alias, Host, Http Port, User and Password
of the camera which is needed to add.
Host is the hostname or internet IP address of the second camera.
Click Add to add camera and then click Submit to save the settings.
You can add more cameras in the same way. Eg: I add three cameras (Foscam
Demo, foscamdemo3, foscamdemo1) here.
www.foscam.com
ShenZhen Foscam Intelligent Technology Co., Limited
Step 2: Access camera with hostname or internet IP address.
Go to For Visitor and then click four windows. You will see all the four cameras.
The indicators on Device Status are green mean camera are added
successfully.
www.foscam.com
ShenZhen Foscam Intelligent Technology Co., Limited
Note:
1. Only on the device which you add other cameras can monitor all these
cameras. If you want monitor on every camera, you need to do the same
settings as above steps.
2. If indicator on Device Status is yellow, that means the parameters is
incorrect. You may get error message like “Fail to connect to the device:
Incorrect user”. You can go back to Multi-Device to check the settings.
www.foscam.com