Belkin F8Z492 User manual

Bluetooth
Music Receiver
®
User Manual
F8Z492 8820tt00264
Table of contents
Table of Contents
sections
1
2
3
4
5
6
1 Introduction������������������������������������������������������������������1
4 Troubleshooting����������������������������������������������������������7
2 Setting Up Your Bluetooth Music Receiver������������ 2
5 Safety Warnings����������������������������������������������������������8
3 Pairing Your Bluetooth Music Receiver������������������ 3
6 Information ������������������������������������������������������������������9
Reconnecting Your Device������������������������������������������������ 5
Changing Connected Device �������������������������������������������� 6
Out of Range or Lost Signal ���������������������������������������������� 6
FCC Statement�������������������������������������������������������������������� 9
Warranty����������������������������������������������������������������������������� 10
Bluetooth® Music Receiver
Introduction
Table of Contents
sections
1
2
3
4
5
6
What’s in the Box
Features
− Play your iPhone, iPod touch, or other
device enabled with Bluetooth technology
wirelessly through your home stereo
− Control your music directly from
your iPhone or iPod touch
− Connect a device without ever going near the stereo
− Bluetooth connection has a 30 ft. range for virtually
unlimited wireless listening in your home
Power
Power
Adapter
Adapter
Bluetooth® Music Receiver
1
3.5mm
3.5mm
3.5mm --3.5mm
stereocable
cable
stereo
3.5mm
- RCA
3.5mm - RCA
stereo cable
stereo
cable
Bluetooth
Music
Bluetooth
Music
Receiver
Receiver
Setting Up Your Bluetooth Music Receiver
Table of Contents
sections
1
2
1. Connect one 3.5mm end of the included
audio cable to the headphone jack of
the Bluetooth Music Receiver.
2. Connect the other end (3.5mm or 2xRCA) to
an audio input on your home stereo system.
Consult your stereo system’s manual for more
information on how to accomplish this.
3. Connect the AC power adapter cable to the
Bluetooth Music Receiver’s DC input jack, and
plug the AC adapter into a wall power outlet.
4. The blue LED light will flash once to indicate
the unit is powered and is now ready to be
paired to your iPhone or iPod touch.
Bluetooth® Music Receiver
2
3
4
5
6
Pairing Your Bluetooth Music Receiver
Table of Contents
sections
1
2
3
4
5
6
1. Go to the Bluetooth
Manager of your
iPhone or iPod
touch by following
these steps:
a. From your iPhone/
iPod touch home
page, tap “Settings”.
Bluetooth® Music Receiver
b. Inside Settings,
tap on “General”.
3
c. Inside General, tap
on “Bluetooth”.
Pairing Your Bluetooth Music Receiver
Table of Contents
sections
1
2
3
4
2. Search Bluetooth
devices and click on
“Belkin YXX” (e.g.,
Belkin A58) where:
6
4. Once paired, the
blue LED light on
the Bluetooth Music
Receiver will flash
once. The blue LED
light will stay on
when a connection
is established.
a. Y = a letter
(A, B, C, etc.)
b. X = a number
(00, 01, 02, etc.)
This is the device ID and
is also printed on the
bottom of the Bluetooth
Music Receiver for
easy reference.
Bluetooth® Music Receiver
5
3. Enter “0000” when
the player asks for the
PIN code. This will
allow the iPhone to
pair with the Bluetooth
Music Receiver.
4
Some devices, such
as the iPhone, will
connect immediately
after pairing so the
LED will stay on.
Other devices, such
as laptops, may ask
you if you wish to
connect and the LED
will go off after pairing
until a connection
is established.
Pairing Your Bluetooth Music Receiver
Table of Contents
sections
1
2
4
5
6
Reconnecting Your Device
Although the Bluetooth Music Receiver can only play
music from one device at a time, it is capable of being
paired to up to eight devices. This means that you only
have to enter the PIN code one time for each device.
If you move out of range or turn off the Bluetooth feature
on your iPhone or iPod touch, the Bluetooth Music
Receiver will disconnect from your device. To reconnect,
simply access the Bluetooth Manager on your device
and select the appropriate Belkin YXX device listed.
You will not be asked to enter the PIN code again. Your Bluetooth Music Receiver is now connected
and ready to play music! Just play music on your
device as you normally would and the sound
will come out of your stereo speakers!
Keep in mind that the Bluetooth Music
Receiver has a 30-foot range.
Bluetooth® Music Receiver
3
5
Pairing Your Bluetooth Music Receiver
Table of Contents
sections
1
2
3
4
5
6
Changing Connected Device
Out of Range or Lost Signal
If you want to switch from one device
to another, follow these steps:
If the music device is out of range (beyond 30 feet) of
the Bluetooth Music Receiver or if there is something
blocking the Bluetooth signal, the LED light will turn
off to indicate that the Bluetooth connection with the
music device has been lost. To avoid a lost connection:
1. End the existing Bluetooth connection
with the connected device. Access the
Bluetooth Manager and disable the Bluetooth
function of the iPhone or iPod touch.
2. The Bluetooth Music Receiver can now be
connected to a different iPhone or iPod touch.
1. Move the music device back into range (within
30 feet), and/or make sure there’s a clear line of
sight and that there are no obstructions between
the Receiver and the iPhone or iPod touch.
3. Follow the directions in “Pairing Your Bluetooth
Music Receiver” to connect a different device.
2. Within 15 seconds, the connection will automatically
be reestablished and the blue LED light will turn on.
3. If the connection is lost for more than 15 seconds,
the connection will need to be reestablished. Follow
the directions in “Reconnecting Your Device”.
Bluetooth® Music Receiver
6
Troubleshooting
Table of Contents
sections
1
2
You can quickly solve most problems with your Bluetooth
Music Receiver by following the advice in this section.
4
5
6
• Make sure the Receiver is powered.
• Make sure the stereo volume is set to
a comfortable listening level.
My music is not coming out of the stereo speakers.
• Make sure you are within range of the Receiver,
and that your iPhone or iPod touch is connected
via Bluetooth technology with the Receiver.
Solutions:
• Make sure the Bluetooth Music Receiver is powered.
• Make sure an audio cable is correctly and firmly
connected to the Bluetooth Music Receiver.
• Make sure one of the two supplied audio
cables is correctly and firmly connected
to the Receiver and the stereo.
Bluetooth® Music Receiver
3
7
Safety warnings
Table of Contents
sections
1
2
Your Bluetooth Music Receiver requires full
concentration and both hands to install.
4
5
6
Belkin does not assume any responsibility for personal
injury or property damage incurred due to interaction
with the Bluetooth Music Receiver, iPhone, or iPod.
Do not use this apparatus near water (for
example, a bath tub, wash bowl, kitchen sink,
laundry tub, wet basement, swimming pool,
or other areas located near water).
Clean only with a dry cloth. Unplug this product
from the wall outlet before cleaning.
Do not install near any heat sources such as stoves or
other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched,
particularly at the plugs, convenience receptacles,
and the point where they exit the apparatus.
Only use attachments/accessories
specified by the manufacturer.
Unplug this apparatus when unused
for long periods of time.
Bluetooth® Music Receiver
3
8
InFormation
Table of Contents
sections
1
2
3
4
5
6
FCC Statement
• Reorient or relocate the receiving antenna.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an outlet on a circuit
different from that which the receiver is connected.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
Bluetooth® Music Receiver
• Consult the dealer or an experienced
radio/TV technician for help.
Belkin International, Inc., is not responsible for any interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate this equipment.
9
InFormation
Table of Contents
sections
1
2
Belkin International, Inc., Limited
1-Year Product Warranty
4
5
6
What is not covered by this warranty?
All above warranties are null and void if the Belkin product is not
provided to Belkin for inspection upon Belkin’s request at the sole
expense of the purchaser, or if Belkin determines that the Belkin
product has been improperly installed, altered in any way, or tampered
with. The Belkin Product Warranty does not protect against acts
of God such as flood, lightning, earthquake, war, vandalism, theft,
normal-use wear and tear, erosion, depletion, obsolescence, abuse,
damage due to low voltage disturbances (i.e. brownouts or sags), nonauthorized program, or system equipment modification or alteration.
What this warranty covers.
Belkin International, Inc. (“Belkin”) warrants to the original
purchaser of this Belkin product that the product shall be free
of defects in design, assembly, material, or workmanship.
What the period of coverage is.
Belkin warrants the Belkin product for one year.
How to get service.
To get service for your Belkin product you must take the following steps:
What will we do to correct problems?
Product Warranty.
1. Contact Belkin International, Inc., at 501 W. Walnut St.,
Compton, CA 90220, Attn: Customer Service, or call
(800)-223-5546, within 15 days of the Occurrence. Be
prepared to provide the following information:
Belkin will repair or replace, at its option, any defective product
free of charge (except for shipping charges for the product).
Belkin reserves the right to discontinue any of its products without
notice, and disclaims any limited warranty to repair or replace any
such discontinued products. In the event that Belkin is unable to
repair or replace the product (for example, because it has been
discontinued), Belkin will offer either a refund or a credit toward
the purchase of another product from Belkin.com in an amount
equal to the purchase price of the product as evidenced on the
original purchase receipt as discounted by its natural use.
Bluetooth® Music Receiver
3
10
a. The part number of the Belkin product.
b. Where you purchased the product.
c. When you purchased the product.
d. Copy of original receipt.
InFormation
Table of Contents
sections
1
2
3
4
5
6
How state law relates to the warranty.
2. Your Belkin Customer Service Representative will then
instruct you on how to forward your receipt and Belkin
product and how to proceed with your claim.
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF
BELKIN. THERE ARE NO OTHER WARRANTIES, EXPRESSED
OR, EXCEPT AS REQUIRED BY LAW, IMPLIED, INCLUDING
THE IMPLIED WARRANTY OR CONDITION OF QUALITY,
MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE
LIMITED IN DURATION TO THE TERM OF THIS WARRANTY.
Belkin reserves the right to review the damaged Belkin product.
All costs of shipping the Belkin product to Belkin for inspection
shall be borne solely by the purchaser. If Belkin determines,
in its sole discretion, that it is impractical to ship the damaged
equipment to Belkin, Belkin may designate, in its sole discretion,
an equipment repair facility to inspect and estimate the cost to
repair such equipment. The cost, if any, of shipping the equipment
to and from such repair facility and of such estimate shall be
borne solely by the purchaser. Damaged equipment must remain
available for inspection until the claim is finalized. Whenever
claims are settled, Belkin reserves the right to be subrogated
under any existing insurance policies the purchaser may have.
Some states do not allow limitations on how long an implied
warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL BELKIN BE LIABLE FOR INCIDENTAL,
SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL OR
MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO,
LOST BUSINESS OR PROFITS ARISING OUT OF THE
SALE OR USE OF ANY BELKIN PRODUCT, EVEN IF
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
This warranty gives you specific legal rights, and you may also have
other rights, which may vary from state to state. Some states do
not allow the exclusion or limitation of incidental, consequential, or
other damages, so the above limitations may not apply to you.
Bluetooth® Music Receiver
11
Belkin Tech Support
US: 800-223-5546, ext. 2263
310-898-1100, ext. 2263
UK: 0845 607 77 87
Australia: 1800 235 546
New Zealand: 0800 235 546
Singapore: 65 64857649
Europe: www.belkin.com/support
Belkin International, Inc.
501 West Walnut Street
Los Angeles, CA 90220, USA
310-898-1100
310-898-1111 fax
Belkin B.V.
Boeing Avenue 333
1119 PH Schiphol-Rijk,
The Netherlands
+31 (0) 20 654 7300
+31 (0) 20 654 7349 fax
Belkin Ltd.
Express Business Park, Shipton Way
Rushden, NN10 6GL,
United Kingdom
+44 (0) 1933 35 2000
+44 (0) 1933 31 2000 fax
Belkin Ltd.
4 Pioneer Avenue
Tuggerah Business Park
Tuggerah, NSW 2259, Australia
+61 (0) 2 4350 4600
+61 (0) 2 4350 4700 fax
© 2009 Belkin International, Inc. All rights reserved. All trade names are registered trademarks
of respective manufacturers listed. iPod, iPhone, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries. The Bluetooth name and the Bluetooth trademarks
are owned by Bluetooth SIG, Inc., and are used by Belkin International, Inc., under license.