APW Wyott FDD-24 Operating instructions

R
INSTALLATION
AND
OPERATING
INSTRUCTIONS
CREAM DISPENSERS
Models:
DAO & DBO
RETAIN THIS MANUAL FOR FUTURE REFERENCE
!
!
WARNING: Improper installation, adjustment, alteration, service or maintenance can
cause
property
damage,
injury
or
death.
Read
the
Installation,
Operating
and
Maintenance Instructions thoroughly before installing or servicing this equipment.
!
Maintenance & repair should be handled by a factory authorized agent. Before doing
any maintenanceor repair, contactAPW Wyott.
!
These models are designed, built, and sold for commercial use. If these models are
positioned so the general public can use the equipment make sure that cautions, warnings, and
operating instructions are clearly posted near each unit so that anyone using the equipment will
use it correctly and not injure themselvesor harm the equipment.
!
CAUTION:
CAUTION:
!
!
IMPORTANT:
Local codes should always be used when installing this equipment.
!
IMPORTANT FOR FUTURE REFERENCE
Please complete this information and retain this manual for the life of the equipment. For
Warranty Service and/or Parts, this information is required.
Model Number
Serial Number
Date Purchased
This equipment has been engineered to provide you with year-round dependable service when used
according to the instructions in this manual and standard commercial kitchen practices.
P/N 88701 9/05
Phone:
+1 (307) 634-5801
Fax:
+1 (307) 637-8071
APW WYOTT
Toll Free: +1 (800) 752-0863
P.O. Box 1829
Website: www.apwwyott.com
E-mail:
Cheyenne, WY 82003
info@apwwyott.com
1
INSTALLATION INSTRUCTIONS
1.
2.
Select the sit for your unit.
Using the base as a template, drill a 1/4”
diameter hole through your counter.
3.
Attach the base to the counter with the
oval head screws, flat washers and keps
nuts.
NOTE: Clean the machine before using it
for the first time.
ASSEMBLY
1.
Attach the machine body onto
the base. Turn the body back
and forth slightly to make sure
it is seated properly.
2.
Widen the ends of the dispensing lever, and insert them through the holes in the base.
3.
Remove the rubber band from the spout and portion adjustment nuts.
4.
Turn the portion adjustment nuts all the way up. The position of these nuts control the portion of
cream you dispense. The farther up they are, the larger the portion.
5.
Pull out the stop button, and push the spout into the nylon stop assembly; then release the stop
button. This locks the spout into place.
6.
Place the cup and piston into the creamer as illustrated.
OPERATION
1.
The machine is supplied with two iceless coolers. Freeze the coolers for about four hours.
NOTE:
An iceless cooler will keep cream cool for up to 4 hours, depending on local conditions.
Use the second cooler when it becomes necessary to re-freeze the first.
2.
Fill the creamer.
3.
Place one cooler in the top of the machine to keep the cream cool.
4.
Adjust the portion adjustment nuts for the desired portion.
5.
To dispense cream from the DAO and DBO, simply lift the handle and release it.
2
CLEANING
1.
Disassemble the machine and wash all parts in detergent and water, running the brush through
the discharge tube assembly and through the spout.
CAUTION:
Do not drop the valve parts or wash them with other metallic objects. Be sure the “0”
Rings are in the grooves of both the spout and piston stem. If they are missing or damaged, the
dispenser will leak.
2.
Rinse well, first in hot water and then in iced water to cool the parts before filling the. Machine
with cream.
3.
Once each week soak all parts in a sanitizing solution for at least 15 minutes, and allow them to air
dry; then reassemble the machine.
SERVICE INFORMATION
When you place a parts order, be prepared to provide the unit's model number, in addition to part
description and part number.
NOTE:
Use only original APW Wyott “0” Rings which are properly sized and made of F.D.A. approvd
material.
ILLUSTRATED PARTS BREAKDOWN
“O” Ring 1/4”
DAO Lid (37)
I.D. X 3/8” O.D.
DBO Lid (118)
(21148)
DAO Cooler (139)
“O” Ring 5/16”
DBO Cooler (145)
I.D. X 7/16” O.D.
Piston w/”O” Rings (274)
(21151)
Cup (46)
“O” Ring 9/16”
Spout w/ “O” Rings (275)
I.D. X 11/16” O.D.
(21151)
DAO Liner Gasket (21009)
DBO Liner Gasket (21163)
DAO Liner (282)
DAO Lower Jacket (8)
DBO Liner (291)
DBO Lower Jacket (259)
DAO Insulation (7)
DBO Insulation (104)
Bottom Gasket (21167)
Gland Gasket (21005)
[DBO Only]
Jacket Bottom (108) [DBO Only]
Portion Adjustment Stud (66)
Gland Nut (20)
Portion Adjustment Nut (24)
Dispensing Lever Assembly
DAO (285)
Lockwasher 1/4” Split (85082)
DBO (286)
Nut (24)
Stop Button (28)
Nylon Stop (27)
Dispensing Lever
DAO Base (48)
DBO Base (127)
Assembly
Screw (81954-00)
Keps Nut (84168-00)
Washer (85053-00)
3
APW WYOTT EQUIPMENT LIMITED WARRANTY
APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the
following conditions:
This warranty applies to the original owner only and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the option of
APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency. APW Wyott will only be
responsible
for
charges
incurred
or
service
performed
by
its Authorized
Service
Agencies.
The
use
of
other
than APW
Wyott
Authorized Service Agencies will void this warranty and APW Wyott will not be responsible for such work or any charges associated
with same. The closest APW Wyott Authorized Service Agent must be used.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, metropolitan areas of Alaska and Canada. There
will be no labor coverage for equipment located on any island not connected by roadway to the mainland.
Warranty coverage on products used outside the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska and Canada
may vary. Contact the international APW Wyott distributor, dealer, or service agency for details.
Time Period
One year for parts and one year for labor, effective from the date of purchase by the original owner. The Authorized Service Agency
may, at their option, require proof of purchase. Parts replaced under this warranty are warranted for the un-expired portion of the
original product warranty only.
Exceptions
*Gas/Electric Cookline:
Models GCB, GCRB, GF, GGM, GGT, CHP-H, EF, EG, EHP. Three (3) Year Warranty on all
component parts, except switches and thermostats. (2 additional years on parts only. No labor on second or third year.)
*Broiler Briquettes, Rock Grates, Cooking Grates, Burner Shields, Fireboxes:
*Heat Strips:
*Glass Windows, Doors, Seals, Rubber Seals, Light Bulbs:
Models FD, FDL, FDD, FDDL.
90 Day Material Only. No Labor.
Two (2) Year Warranty on element only.
90 Day Material Only.
No labor second year.
No Labor.
In all cases, parts covered by extended warranty will be shipped FOB the factory after the first year.
Portable Carry In Products
Equipment weighing over 70 pounds or permanently installed will be serviced on-site as per the terms of this warranty. Equipment
weighing 70 pounds or under, and which is not permanently installed, i.e. with cord and plug, is considered portable and is subject to
the
following
warranty
handling
limitations.
If
portable
equipment
fails
to
operate
in
its
intended
manner
on
the
first
day
of
connection, or use, at APW Wyott's option or its Authorized Service Agency, it will be serviced on site or replaced.
From day two through the conclusion of this warranty period, portable units must be taken to or sent prepaid to the APW Wyott
Authorized Service Agency for in-warranty repairs. No mileage or travel charges are allowed on portable units after the first day of use.
If the customer wants on-site service, they may receive same by paying the travel and mileage charges. Exceptions to this rule: (1)
countertop warmers and cookers, which are covered under the Enhanced Warranty Program, and (2) toasters or rollergrills which have
in store service.
Exclusions
The following conditions are not covered by warranty:
*Equipment
failure
relating
to
improper
installation,
improper
utility
connection
or
supply
and
problems
due
to
ventilation.
*Equipment that has not been properly maintained, calibration of controls, adjustments, damage from improper cleaning
and water damage to controls.
*Equipment that has not been used in an appropriate manner, or has been subject to misuse or misapplication, neglect,
abuse, accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot or act of god.
*Equipment that has the model number or serial number removed or altered.
If the equipment has been changed, altered, modified or repaired by other than an Authorized Service Agency during or after the
warranty period, then the manufacturer shall not be liable for any damages to any person or to any property, which may result from the
use of the equipment thereafter.
This warranty does not cover services performed at overtime or premium labor rates. Should service be required at times which
normally involve overtime or premium labor rates, the owner shall be charged for the difference between normal service rates and such
premium rates. APW Wyott does not assume any liability for extended delays in replacing or repairing any items beyond its control.
In all cases, the use of other than APW Wyott Authorized OEM Replacement Parts will void this warranty.
This equipment is intended for commercial use only. Warranty is void if equipment is installed in other than commercial application.
Water Quality Requirements
Water supply intended for a unit that has in excess of 3.0 grains of hardness per gallon (GPG) must be treated or softened before
being used. Water containing over 3.0 GPG will decrease the efficiency and reduce the operation life of the unit.
Note: Product failure caused by liming or sediment buildup is not covered under warranty.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSES
AND CONSTITUTES THE ENTIRE LIABILITY OF APW WYOTT. IN NO EVENT DOES THE LIMITED WARRANTY
EXTEND BEYOND THE TERMS STATED HEREIN.”
9/05
4