Cleveland Splash Proof Table Top Gas-Fired Kettle KGT-12

Project ________________________________
™
Cleveland
Item __________________________________
GAS KETTLES
Approval _______________________________
Quantity _______________________________
FCSI Section ____________________________
Date __________________________________
MODELS: � KGT­6­T
� KGT­12­T
TABLE TOP, GAS­FIRED KETTLES
TILTING, 2⁄3 STEAM JACKETED
“SPLASH PROOF SERIES”
6 or 12 GALLONS (23 or 45 LITERS)
Cleveland Standard Features
■ Self contained gas tilting kettle is easily installed, only needs a
■
gas connection and a 115 volt outlet.
■ Precise, consistent temperature control, less than 1°C
■
temperature variance (ideal for simmering). Operating
temperature range from 145°­ 260°F (63°C­127°C).
■ “Splash Proof” solid state control panel for temperature,
■
low water safety, and power “on/off” switch. Accurate L.E.D.
indicators for heat cycle and low water warning.
■ Kettle and all exterior surfaces are a 304 Stainless Steel
■
with a #4 finish.
■ Energy efficient (65%), high performance gas­fired
■
heating system for fast heat up and recovery time:
■ Six gallon model with a 34,000 BTU firing rate, and
■ 22,100 BTU directly applied to the product.
■ Twelve gallon model with a 53,000 BTU firing rate, and
■ 34,450 BTU directly applied to the product.
■ Supplied with Gas Pressure Regulator.
■
■ Standard for natural gas operation.
■
■ Self locking marine type tilting mechanism prevents
■
accidental tilting. Balanced design makes it easy to tilt. The tilt
handle easily mounts on left or right side. Double safety gas
shut off turns off the gas when the unit is tilted.
■ Large pouring lip for easier, faster pouring. Heavy duty
■
Rolled Rim design provides strong reinforcement, prevents
damages from abuse.
Short Form Specifications
■ “Splash Proof” pressure/vacuum gauge.
■
Shall be CLEVELAND, gas kettle, Table Type, self­contained, tilting,
Model KGT­ _____­T; _____ gallons, natural or LP gas, 2/3 steam jack­
eted, type 304 Stainless Steel and supports. Jacket rated at 50 psi
with Safety Valve. Complete with solid state water level, tempera­
ture, and safety low water power cut off, including LED indicators.
Optional lift off cover.
■ Steam jacket permanently filled with treated distilled
■
water, venting and / or refilling is not required.
■ 50 PSI Steam Jacket Rating. Safety valve mounted toward
■
rear of kettle to avoid tampering.
■ Automatic Electronic Spark Ignition System.
■
■ Supplied with cord and plug for 115 volt controls.
■
❐ Food Strainers (FS)
■ Typical approvals include AGA, CSA, NSF and ASME.
■
❐ Measuring Strips (MS)
❐ Spray Hose (PRS­K)
❐ Lift Off Cover (CL)
Options & Accessories
❐ Stainless Steel equipment stand with sliding drain drawer and
splash shield (ST­28)
❐ Hot and cold water faucet (DPK), or Cold Water (SPK).
Requires bracket (FBKT)
❐ Propane Gas Operation (PG)
❐ Kettle Markings (KM)
❐ Protective Control Panel (PCE)
❐ 316 Stainless Steel Liner (316G)
❐ Cooking Baskets (BS)
SECT.
1333 East 179 St.,
Tel: 1-216-481-4900
Web Site: www.ClevelandRange.com
Cleveland, Ohio, U.S.A. 44110
Fax: 1-216-481-3782
Email: Steam@ClevelandRange.com
IX
PAGE
1A
0609
• CAPACITIES: (in 4 oz. servings, other
sizes may be calculated)
16 gallons / 23 liters .......192 servings
12 gallons / 45 liters .......352 servings
5/16-18 THREADED BUSHING
(FOUR PLACES)
A
14.50”
(368mm)
2.00”
(51mm)
F
B
10.00”
(254mm)
14.50”
(368mm)
BASE MOUNTING DETAIL
A
4.00”
(102mm)
C (I.D.)
DOUBLE
PANTRY
FAUCET
(Optional)
E
D
G
1.75”
(44mm)
Manufacturer must be notified if unit will be operated above 2,000 ft. [610m] altitude.
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Installation of backflow preventers, vacuum breakers and other specific coder requirements is the responsibility of the owner and installer.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., A.G.A., NSF, ASME/N.Bd., CSA, CGA, ETL and others.
IX
2A
(NOT TO SCALE)
SECT.
PAGE
0609
Litho in U.S.A.