IP Link® De vice Interface
Communication Sheet
rgbs_31_4078_1.pke
Revision: 3/4/2010
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user's manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Other
RGB Spectrum
N/A
DGY 201x
Version History:
Driver
Version
Date
1
3/1/2010
IP Link
Compiler
GC
Version
1.4.0
3.0.3
Notes
Initial version.
Driver Notes:
This driver will not function properly if the Echo mode is on. Please check with the manufacturer for way to turn
off the Echo mode.
Page 1 of 3
IP Link® De vice Interface
Communication Sheet
rgbs_31_4078_1.pke
Revision: 3/4/2010
Control Commands & States:
Audio Input
Mic
Line
Audio Mode
Left
Right
Stereo
Off
Back Up Re cord
On
Off
Input Source
RGB
DVI
Output Source
RGB
DVI
Transport
Record
Stop
Play
Pause
Next
Previous
Audio Input
Mic
Line
Audio Mode
Left
Right
Status Available:
Stereo
Off
Back Up Re cord
On
Off
Connection Status
Connected
Disconnected
Input Source
RGB
DVI
Output Source
RGB
DVI
Status Unavailable
MLC62 Supported Commands:
Audio Input
Mic
Line
Audio Mode
Left
Right
Stereo
Off
Back Up Re cord
On
Off
Input Source
RGB
DVI
Output Source
RGB
DVI
Transport
Record
Stop
Play
Pause
Next
Previous
Page 2 of 3
rgbs_31_4078_1.pke
IP Link® De vice Interface
Communication Sheet
Revision: 3/4/2010
Cable and Adapter Requirements:
M/F RS-232 straight serial cable (Extron Electronics P/N 26-433-XX)
Notes for the Device:
To ensure the full support of our controller, please use only hardware for the flow control setting and try short circuit
RT S and CT S on the DGY 201x if the controller doesn’t have RT S and CT S pins. Please contact the manufacturer or
the manual for way to change this setting.
Serial communication:
Port Type : RS-232
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: Hardware
Pin Assignments Diagram:
Note: Captive screw connector may also be used as a serial connection.
General Notes:
Page 3 of 3