Samsung DJ68-00339U Operating instructions

DJ68-00339U (EN)-0.3
8/19/08 2:25 PM
Page 1
Operating Instructions
VACUUM CLEANER
❈ Before
❈ Indoor
operating this unit, please read the instructions carefully.
use only.
Register your product at www.samsung.com/global/register
DJ68-00339U (EN)-0.3
8/19/08 2:25 PM
Page 2
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do not
allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run
unattended at any time. Use the vacuum cleaner only for its intended use as described in
these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in
order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the
vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour
the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not
block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from the
electrical outlet. Disconnect the plug from the electrical outlet before changing the dust
bag or dust container. To avoid damage, please remove the plug by grasping the plug
itself, not by pulling on the cord.
8. This appliance is not intended for use by young persons or infirm persons without
supervision unless they are adequately supervised by a responsible person to ensure that
they can use the appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
9. The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult
an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
13. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
1
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 3
▼
1 ASSEMBLING THE CLEANER
OPTION
Features may vary according to model.
CAUTION
Please do not press the button of
dust bin handle when carrying
machine.
For storage, park the floor nozzle.
2
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 4
2 OPERATING THE CLEANER
2-1 ON/OFF SWITCH
1) BODY CONTROL TYPE
2) ON/OFF TYPE
2-2 POWER CORD
NOTE
When removing the
plug from the
electrical outlet, grasp the
plug, not the cord.
2-3 POWER-CONTROL
1) SILDE CONTROL TYPE ONLY (Optional)
• SLIDE TO THE STOP POSITION
Vacuum-cleaner switches off (stand by mode)
• SLIDE FORWARD TO MAX
Suction capacity increases smoothly up to maximum.
2) BODY-CONTROL TYPE / ON/OFF TYPE
- HOSE
To reduce suction for cleaning draperies,
small rugs, and other light fabrics, pull the
tap air until the hole is open.
- BODY (BODY-CONTROL TYPE ONLY)
MIN = For delicate surface e.g. net curtains.
MAX = For hard floors and heavily soiled carpets.
3
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 5
▼
2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
PIPE
Adjust the length of the telescopic
pipe by sliding the length control
button located in the center of the
telescopic pipe back and forth.
ACCESSORY
To check for blockages, separate
the telescopic pipe and adjust to
shorten. This allows for easier
removal of waste clogging the tube.
Push the accessory on to
the end of the hose handle.
Pull out and turn the dusting brush for cleaning delicate areas.
To use the upholstery tool,
push the accessory on to
the end of the hose handle
in the opposite direction.
OPTION
ŠCarpet
Cleaning
ŠFloor
Cleaning
Adjust the inlet lever according to the
floor surface.
4
Remove waste matter completely if the
inlet is blocked.
DJ68-00339U (EN)-0.3
OPTION
OPTION
8/19/08 2:26 PM
Page 6
- Detach transparent drum cover for easy cleaning.
Clogs on turbine keep brush from turning, thus need to be unclogged as follows.
Turbine
Brush
Brush for blanket
For picking up pet
hair and fibre on
upholstery and bed
linen.
OPTION
Remove waste
Turn the lock button to
matter com‘UNLOCK’, and remove
pletely when
inlet is blocked. waste matter.
To reassemble, align the cover to
the front of the main body and
close. After closing the cover,
ensure that the lock button is
turned to the ‘LOCK’ position.
Warning : Use for bedclothes only. Be cautious not to damage brush
during unclogging.
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
1
2
3
Remove waste matter
Remove the brushbar such as dust and hair
Push the Open button of
from the transparent tangled around the
the transparent screen
brushbar using scissors.
cover to separate the cover. screen.
4
5
6
For improved pickup of pet hair and
fibre on carpets
Remove dust inside the Insert brushbar into
brush housing using a
rotating belt and
dry duster or crevice tool. assemble.
5
Click the transparent
screen cover back into
place to reassemble.
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 7
3 EMPTYING THE DUST BIN
1
2
Option
Once dust reaches the dust full
mark, or once the dust
full light is on, empty the dust bin.
3
Take the dust bin out by
pressing the button.
Separate the dust
bin cover.
CLICK
4
5
Throw away dust into
the bin.
6
Close the dust bin cover.
- Empty into a plastic bag
(recommended for asthma/allergy sufferers)
NOTE
You may rinse the dust bin with cold water
6
Before use, push the dust bin
into the main body of the vacuum cleaner until you hear
the "click" sound.
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 8
4 CLEANING THE DUST PACK
4-1. WHEN TO CLEAN THE DUST PACK
- If suction is noticeably reduced during cleaning, please check the dust pack as indicated
below.
Suction is significantly weakened during cleaning.
Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.
Turn the vacuum power to 'MAX'
HANDLE CONTROL
If the filter check indicator turns red
with the inlet floating 10 cm above
flat floor, clean it.
When the indicator light comes
on, please empty the Dust
Pack(4-2) as shown in the following illustrations.
7
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 9
4-2 CLEANING THE DUST PACK
1
3
2
Remove the dust bin and dust
pack as shown.
4
Remove the fixed frame
of the dust pack cover.
5
Wash the sponge and the filter
of the dust pack with water.
7
Remove the sponge and filter
from the dust pack.
6
Let the sponge and filter dry
in the shade for more than
12 hours.
Put the sponge and filter
into the dust pack.
8
Before reassembly,
align the dust pack cover
and dust pack correctly.
Put the assembled dust pack
into the main body.
NOTE : Make sure the filter is completely dry before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
8
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 10
5 CLEANING THE MOTOR PROTECTION FILTER
Remove the motor protection filter from
the vacuum cleaner.
Shake and tap the dust from it and put
back in machine.
Take out both the dust bin and the
dust pack.
6 CLEANING THE OUTLET FILTER
Press the fixed frame
part at the back of the
main body to remove.
Pull out the HEPA Filter Dust the HEPA filter.
using the tab.
Put the HEPA filter into
the main body until you
hear a ‘click’ sound.
OPTION - MICRO CARBON FILTER
NOTE : Replacement filters
are available at your
local Samsung distributor.
Remove and replace the blocked outlet filter.
9
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 11
- IF YOU HAVE A PROBLEM
PROBLEM
Motor does not start.
CAUSE
REMEDY 0
No power supply.
Thermal cut-out.
Nozzle, suction hose or tube
is blocked.
Check cable, plug and socket.
Leave to cool.
Check for blockage and
remove it.
Check that the cord is not
twisted or wound unevenly.
Pull the cord out 2-3m and
push the cord rewind button.
Vacuum cleaner does not
pick up dirt.
Crack or hole in hose.
Check hose and replace if
required.
Low or decreasing suction
Filter is full of dust.
Please check filter and, if
necessary, clean as illustrated in the instructions.
Suction force is gradually
decreasing.
Cord does not rewind fully.
10
DJ68-00339U (EN)-0.3
8/19/08 2:26 PM
Page 12
If you have any questions or comments relating to Samsung products,
please contact the SAMSUNG customer care center.
Country
AUSTRALIA
HONG KONG
MALAYSIA
SINGAPORE
Customer Care Center ☎
1300 362 603
3698-4698
1800-88-9999
1800-SAMSUNG (7267864)
Web Site
www.samsung.com/au
www.samsung.com/hk
www.samsung.com/my
www.samsung.com/sg
DJ68-00339U REV(0.3)