Digital Watchdog DWC-D1363D922 Instruction manual

High Resolution Indoor Dome
Camera
DWC-D1362D
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
08092012
PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference. when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.
2
TABLE OF CONTENTS
Introduction
Installation
Features
4
Parts and Descriptions
5
Dimensions
6
Inside the Box
7
Installation Instructions
8-9
Connecting to Monitors
10
Adjusting the Camera Lens
11
Adjusting the Camera’s Position
12
13
Troubleshooting
Warranty Information
14-15
Specifications
16-17
Memo
18-19
3
FEATURES*
1/3” CCD
570 TV Lines (B&W), 540 TV Lines (Color)
3.3~12mm Varifocal Auto Iris Lens
Electronic Day and Night
BLC (Backlight Compensation)
AWB (Auto White Balance)
DRC (Dynamic Range Compressor)
HME (Highlight Masking Exposure)
Programmable Privacy Zones & Motion Detection
Easy Icon Driven OSD Menu with Built-In Joystick
Wide Operating Voltage (8VDC-18VDC)
Secondary Video-BNC Output
4
PARTS & DESCRIPTION*
1
2
3
4
5
6
7
Lens
Power Input Connector (12VDC)
Primary Video-BNC Output Connector
Bottom Case
Mounting Screws
Outer Dome Cover
Assembly Screws
3
2
4
1
5
6
7
5
DIMENSIONS IN MILLIMETERS (IN)*
7.0(0.28”)
5.0(0.2”)
46.5
(1.83”)
46.5
(1.83”)
85.0(3.35”)
88.0(3.46”)
123.8(4.9”)
6
82.5(3.25”)
INSIDE THE BOX*
Included with D1 Indoor Dome Camera
1
2
3
User Manual
Mounting Template
2 Machine Screw and 2 Dry Wall Anchors
4
5
6
Miniature TORX Driver
L-Key
Secondary Video-BNC Cable
7
CAMERA INSTALLATION*
1
Cut a hole in the ceiling for
routing the cables. Use your
mounting template to mark
the screw holes.
2
Drill holes into the drywall
and insert the drywall
mounts into the holes.
3
Pull wires through and
make connections.
4
Mount and secure the
camera to the surface
using the machine screws.
5
Position the lens, and
adjust the zoom and focus.
6
Assemble the outer dome
cover with the camera
module.
8
WALL MOUNT INSTALLATION*
1
Check to see all parts are
in the box.
2
Use the mount to mark the
pilot holes are required. Drill
holes into the drywall and
insert the drywall mounts.
3
Secure the wall mount to the
wall using the mounting
screws.
4
Attach the base of the camera
to the wall mount with the
smaller machine screws.
5
Position the lens, and
adjust the zoom and focus.
6
Assemble the outer dome
cover with the camera
module.
9
CONNECTING TO MONITORS*
DC12V / AC24V
Video Output
BNC Cable
Main Monitor
10
ADJUSTING THE CAMERA LENS*
Focus Handle
Zoom Handle
1
2
3
4
Loosen the zoom and focus handles by rotating them counter-clockwise.
Adjust the field of view by moving the handle to the RIGHT (tele) to zoom in or to the LEFT (wide)
to zoom out.
AFTER the desired zoom position is established, adjust the focus the same way as described
above.
Once the desired adjustments have been made, please tighten the handles back by turning them
clockwise.
11
ADJUSTING THE CAMERA’S POSITION*
60.0° Tilt
12
360.0° Pan
TROUBLESHOOTING
Before sending your camera for repair, check the following or contact our technical
specialist.
FOR NO VIDEO
Check the coaxial cable and make sure it is connected securely.
Check the lens’ iris adjustment at the camera’s OSD menu.
Check the power supply and make sure the camera has the proper voltage and
current.
FOR OUT-OF-FOCUS VIDEO
Check the clear dome cover and the lens for dirt or fingerprints. Use a soft cloth and
gently clean. Check the lens’ manual focal and zoom adjustment. The use of a field
test monitor is recommended.
13
WARRANTY INFORMATION*
Digital Watchdog (referred to as “the Warrantor”) warrants the Digital Watchdog Camera
against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years and one (1) year on IR LED from the original purchase
date, if the camera is determined to be defective, the Warrantor will repair or replace the
unit with a new or refurbished product at its option at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for the initial five (5) years
and one (1) year on IR LED.
To obtain warranty or out of warranty service, please contact a Technical Support
Representative at 1-866-446-3595 Monday through Friday from 8:30AM to 8:00PM
Eastern Standard Time.
A purchase receipt or other proof of the original purchase date is required before warranty
service is rendered. This warranty only covers failures due to defects in materials and
workmanship which arise during normal use. This warranty does not cover damage which
occurs in shipment or failures which are caused by products not supplied by the Warrantor or
failures which result from accident, misuse, abuse, neglect, mishandling, misapplication,
alteration, modification, faulty installation, set-up adjustments, improper antenna, inadequate
signal pickup, maladjustment of consumer controls, improper operation, power line surge,
improper voltage supply, lightning damage, rental use of the product or service by anyone other
than an authorized repair facility or damage that is attributable to acts of God.
14
LIMITS & EXCLUSIONS*
There are no express warranties except as listed. The warrantor will not be liable for incidental
or consequential damages (including damage to recording media without limitation) resulting
from the use of these products or arising out of any breach of the warranty. All express and
implied warranties, including the warranties of merchantability and fitness for particular
purpose, are limited to the applicable warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or
limitatons on how long an implied warranty lasts, so the exclusions or limitations listed above
may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights that vary from state-to-state.
If the problem is not handled to your satisfaction, then write to the following address:
Digital Watchdog, Inc.
ATTN: RMA Department
5436 W. Crenshaw Street
Tampa, FL 33634
Service calls which do not involve defective materials or workmanship as determined by the
Warrantor, in its sole discretion, are not covered. Costs of such service calls are the
responsibility of the purchaser.
15
SPECIFICATIONS*
DWC-D1363D & DWC-D1363D922
VIDEO
Image Sensor
Total Pixels
Effective Pixels
Frequency
Synchronization
Horizontal Resolution
Minimum Illumination
S/N Ratio
Video Output
LENS
Focal Length
Lens Type
1/3" CCD
811 (H) x 508 (V), 411K Pixels
768 (H) x 494 (V)
15.734KHz (H), 59.95Hz (V)
Internal or Line Lock
570 TV Lines [B&W], 540 TV Lines [Color]
F1.2 (30IRE): 0.01 Lux [Color]
F1.2 (30IRE): 0.00 Lux [B&W]
52dB (AGC off)
CVBS: 1.0Vp-p / 75 Ω
3.3-12mm
DC Auto Iris
OPERATIONAL
Day & Night
3D-DNR
Back Light Compensation
Electronic
OFF / LOW / MID / HIGH / SMART
OFF / BLC / HME / DRC
Privacy Zones
Language
OFF / ON (4 Programmable Zones)
ENGLISH / CHINESE
16
ENVIRONMENTAL
Operating Temperature
Operating Humidity
Storage Temperature
ELECTRICAL
Power Requirement
Power Consumption
12VDC
12VDC: 1.1, 91.7mA
MECHANICAL
Housing Material
Dome Cover Material
Dimensions
Weight
Plastic
Polycarbonate
∅123.8 x 85 mm (∅4.9 X 3.35 in)
0.7 lbs
o
o
o
o
-10 C ~ 55 C (14 F ~ 131 F)
Less than 90% (Non-Condensing)
-20oC ~ 70oC (-4oF ~ 158oF)
*Specification is subject to change without prior notice.
17
MEMO*
18
MEMO*
19
5436 W Crenshaw St. Tampa, FL 33634
Tel : 866-446-3595 / 813-888-9555
Fax : 813-888-9262
www.Digital-Watchdog.com
technicalsupport@dwcc.tv
Technical Support Hours : Monday-Friday
8:30am to 8:00pm EST