Installation Addendum for

Stanley Omnilock 9KOM

Extreme Weatherized Locks

Retractor

Latch tube prong

Latch tailpiece

Latch tube prong

Chassis frame

Chassis

Figure 1 Installing the lock chassis and engaging the retractor in the latch

Module bracket

Connecting cables

Grounding wire

9KOM Extreme Weatherized Cylinder Locks

This addendum begins after step 6 of Installation Instructions for Stanley Omnilock 9KOM Cylinder Locks T83303.

1 From the outside of the door, insert the lock chassis and outside escutcheon into the 2 1/8” (54 mm) chassis hole.

2 Make sure that the latch tube prongs engage the chassis frame and that the latch tailpiece engages the retractor. See .

3 Thread connecting cables and grounding wire through the door cable hole. Use screws to attach the

module bracket from the inside of the door. See Figure 2.

Note: Ensure that no wires are pinched when attaching the escutcheon to the door.

4 Connect the batteries and wires as shown in Figure 3.

5 Secure the extreme weather module cover with the security screws provided. See Figure 4.

6 Continue with step 10 of the Installation Instructions for Stanley Omnilock 9KOM Cylindrical Locks (T83303) to finish installation.

Security screws

12 Pin

Connector

Wire inlet

Cover grounding wire

10 Pin

Connector

Grounding wire

Wire inlet

Figure 2 Inside circuit module Figure 3 Wire connections to circuit module Figure 4 Inside view of weatherized model

T83319/Rev A 0000000 ER-7991-12 Jan 2010

Stanley Omnilock a Product Group of Stanley Security Solutions, Inc.

door

Inside

T83310 template right hand

ertical Centerline template holes from

T83310 existing mplate

left hand

Templa for 9K

Cylinder L theriz