Dunavox DX-45.158K Instruction manual

INSTRUCTION MANUAL
FOR WINE COOLER
MODEL NO.
DX-45.158K
DX-143.392K
DX-154.396K
Thanks for buying our wine cooler, wish our advanced product will take care of your wine very
well and you can have joyful taste. Before use, please read and follow all safety rules and
operating instructions.
1
SAFETY INSTRUCTIONS ATTENTION
WARNING
To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these
basic precautions:
READ ALL INSTRUCTION BEFORE USING THE WINE COOLER.
This appliance can be used for wine storage only!
Don't let children operate the wine cooler or seek connections with any position of the
cabinet, in case that the cabinet turnover and cause the bodily injury.
After the appliances are junked or abandoned, please remove the glass door of cabinet, and
Choose an authorized disposal site.
Please don’t clear the cabinet with flammable liquid, in order to avoid cause the fire or
explodes. Flammable and explosive articles should not be put in or near the cabinet, to
avoid the fire or explode caused.
Flammable and explosive articles should not be put in or near the cabinet, to avoid the fire
or explode caused.
Please guarantee the properly grounded outlet of the cabinet, please be out of use
immediately when touching the cabinet and feeling leaks electricity, pull out the plug and
ask the professional engineer to repair.
If the cable is damaged, please let the after-sale service or eligible technical personnel
change, in order to avoid causing danger. PLEASE DON’T TRY TO PLUG INTO OR
EXTENSION THE CABLE IN ANY CASE.
WARNING:
To prevent the door gasket being damaged, make sure to have the door all the way opened
once pulling shelves out.
Please put the cabinet in the position close to the plug.
Please put the cabinet in the position close to the plug. Don’t move your cabinet while
loaded with wine.
Please put in the suitable place to avoid touching the compressor with hands.
INSTALLION INSTRUCTIONS:
BEFORE USING YOUR WINE COOLER
Remove the exterior and interior packing.
Before connecting the Wine Cooler to the power source, let it stand upright 48 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surgace with lukewarm water with a soft cloth.
Install the handle on the left side of the door.(If with handle)
INSTALLION OF YOUR WINE COOLER
This appliance is designed to be for free standing installation or built-in(fully recessed).
Place your Wine Cooler on a floor that is strong enough to support it when it is fully
loaded. Do not place the appliance on floor heated area!
To lever your Wine Cooler, adjust the leveling leg at the level position.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, radiator,
2
electric radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
Avoid locating the unit in moist area.
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet.
INSTALLION DRAWING
In order to let your units working on good conditions, please make sure to keep sufficient
air circulation for cabinet.
Please strict accordingly to below installation drawing to well install your cabinet.
Model DX-45.158K
Model DX-143.392K & DX-154.396K
3
OPERATING YOUR WINE COOLER AND SETTING THE TEMPERATURE
CONTROL
Please use the cabinet under 5-35 ambient temperature, if the ambient temperature is higher
than or lower than this temperature, it will cause the temperature fluctuation in the cabinet,
maybe can't reach 5-18 .
CONTROLL SYSTEM INSTRUCTION :
DX-45.158K
LIGHT
Control the interior light ON/OFF
RUN
When it’s ON, the cooling system runs.
Power
control this appliance turn on/off. ( press and hold this buttons for approximately
3 seconds);
“Set Upper” BUTTER
The temperature setting can be adjusted from 5 to 10 (41 to 50 ).
When pressing this button, the system will be entering the set up mode in the upper
compartment automatically. The LED will flashing and display the setting temperature.
Press once the button, the temperature will decrease 1 (or 1 ). When exceeding the
minimum value that can be established, it will jump to the highest adjustable temperature
value automatically. After stopping pressing the button for 5 seconds, LED figure will
stop flash, then revert back to display the temperature of the upper compartment.
“Set Lower” BUTTER
Set up the temperature in lower compartment: The temperature setting can be adjusted
from 10 to 18 (50 to 64 ).
When pressing this button, the system will be entering the set up mode in the upper
compartment automatically. Setting details same as above.
“Upper chamber”
Display the actual temperature in upper compartment.
“Lower Chamber”
Display the actual temperature in lower compartment.
After the unit is unplugged, the system will return to acquiescence temperature, which
setting by factory. The acquiescence temperature as below:
Upper compartment: 6
Lower compartment: 12
If want reveal every indoor setting temperature, please corresponding to press " Set Upper
" or " Set Lower " button, the LED will flash and display the setting temperature. After
stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to
4
display the actual temperature.
DX-154.396K
Light
Control the interior light ON/OFF
RUN
When it’s ON, the cooling system runs.
Power
control this appliance turn on/off. ( press and hold this buttons for approximately
3 seconds);
“Set Upper” BUTTER
The temperature setting can be adjusted from 5 to 18 (41 to 65 ).
When pressing this button, the system will be entering the set up mode in the upper
compartment automatically. The LED will flashing and display the setting temperature.
Press once the button, the temperature will decrease 1 (or 1 ). When exceeding the
minimum value that can be established, it will jump to the highest adjustable temperature
value automatically. After stopping pressing the button for 5 seconds, LED figure will
stop flash, then revert back to display the temperature of the upper compartment.
“Set Lower” BUTTER
Set up the temperature in lower compartment: The temperature setting can be adjusted
from 5 to 18 (41 to 65 ).
When pressing this button, the system will be entering the set up mode in the upper
compartment automatically. Setting details same as above.
“Upper chamber”
Display the actual temperature in upper compartment.
“Lower Chamber”
Display the actual temperature in lower compartment.
After the unit is unplugged, the system will return to acquiescence temperature, which
setting by factory. The acquiescence temperature as below:
Upper compartment: 7
Lower compartment: 12
If want reveal every indoor setting temperature, please corresponding to press " Set Upper
" or " Set Lower " button, the LED will flash and display the setting temperature. After
stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to
display the actual temperature.
5
DX-143.392K
The controls of your Wine cooler
℃
Power
Light
(the upper zone and middle zone)
℃
RUN
Set Upper
Set Middle
Upper Chamber
Middle Chamber
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
Light
To control the inner light turn on/off.
Power
To control this appliance turn on/off.
“Set Upper” Button
To set the temperature of the upper chamber.
“Set Middle” Button
To set the temperature of the middle chamber.
“Up chamber”
To shows the temperature of the up chamber.
“Middle chamber”
To shows the temperature of the middle chamber.
Setting the Temperature Control
Each cooling compartment of the wine cooler (upper & lower) is independently controlled. To
set the temperature:
• Connect the power cord to a properly grounded outlet. In the event of a power interruption,
all previous temperature settings are automatically erased and each compartment will
default to a preset temperature setting of: 7°C for upper compartment and 12°C for
middle compartment.
• Set the desired cooling temperature by pressing the buttons adjacent to the “Set Upper/Set
Middle” program. Each depression of the buttons will scroll through the available
temperature settings (for each compartment) in increments of 1 degree. The temperature
selected will flash in the LED display for approximately 5 seconds, then revert back to
display the temperature of the internal cabinet
Upper compartment:The temperature setting can be adjusted from 5°C to 18°C.
Middle compartment: The temperature setting can be adjusted from 5°C to 12°C.
•
To view the “Set” temperature (anytime) press and hold the corresponding button, the
“Set” temperature will temporarily “flash” in the LED display for 5 seconds.
The controls of your Wine cooler
(the Lower zone)
6
C
RUN
UP
DOWN
DISPLAY
“UP” Button
Used to raise(warm) the temperature in 1 .
“DOWN” Button
Used to lower(cool) the temperature in 1 .
“DISPLAY”
To shows the temperature of the lower compartment.
Setting the Temperature Control
•
•
•
•
To set the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption,
all previous temperature settings are automatically erased and it will default to a preset
temperature setting of: 7 .
Set the desired cooling temperature by pressing the buttons adjacent to the “UP/DOWN”
program. Each depression of the buttons will scroll through the available temperature
settings in increments of 1 degree. The temperature selected will flash in the LED display
for approximately 5 seconds, then revert back to display the temperature of the internal
cabinet
The temperature setting can be adjusted from 12 to 18
SHELFS
DX-45.158K DX-1543.396K
•
•
DX-143.392K
To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of
the rail compartment, however this unit was designed with a notch on each sides of the
shelf tracks to prevent bottles from falling.
Put the shelf gap(left and right) under the square plastic block, uptilt the shelf,then pull the shelf from
the Wine Cooler.
GENERAL INSTRUCTION FOR WINE COOLER
7
USING ATTENTION
Store wine in sealed bottles.
Do not overload the cabinet.
Do not open the door unless necessary
Do not cover shelves with aluminum foil or any other shelf material, which may prevent
air circulation.
Should the wine cooler be stored without use for long periods it is suggested, cut off the
power and careful cleaning, leave the door ajar to allow air to circulate inside the cabinet
in order to avoid possible formations of condensation, moldy or odors.
ATTENTION
If the unit is unplugged, power lost, or turned off, you must wait 3 to5 minutes before
restart the unit. If you need attempt to restaet before this time delay, the Wine Cooler will
not start. If first time use or longer absence of using, the temperature will difference
between setting and LED display temperature. After running a period, the temperature will
be reverting back.
CARE & MAINTENANCE
CLEAN YOUR WINE COOLER
Turn off the power, unplug the appliance, and remove all items including shelves and rack.
Wash the inside surfaces with a warm water and mild solution.
Wash the shelves with a mild detergent solution.
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe
dry with a clean soft cloth.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature
of your appliance if you minimize the number of times the door is opened. If the power is
going to be off for a long period of time, you need to take the proper steps to protect your
contents.
VACATION TIME
Short vacations: Leave the Wine Cooler operating during vacations of less than three
weeks.
If the appliance will not be used for several months, remove all items and turn off the
appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave
the door open slightly: blocking it open if necessary.
MOVE YOUR WINE COOLER
Remove all items.
Take out the loose items inside the wine cooler (such as shelf), or fix the loose items with
the foam.
Turn the adjustable leg up to the base to avoid damage.
Tape the door shut.
Be sure the appliance stays secure in the upright position during transportation. Also
protect outside of appliance with a blanket or similar items.
ENERGY SAVING TIPS
The Wine Cooler should be located in the coolest area of the room, away from producing
appliances, and out of the direct sunlight.
8
ALL THE APPLIANCES ARE DESIGNED QITH LED LIGHE, IF LED LIGHT
DAMAGE ,PLEASE CONTACT WITH AFTER-SALE SERVICE TO REPLACE
IT.
PROBLEMS WITH YOUR WINE COOLER
You can solve many common Wine Cooler problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you solve the problem before calling the
servicer.
TROUBLESHOOTING GUIDE
Problem
Wine Cooler does not operate
Wine Cooler is not cold enough
Turns on and off frequently
The light does not work
Vibrations
Too much noise
The door will not close properly
Possible Cause
No plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is hotter than normal.
Overload of the cabinet
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has borned out.
The light button is “OFF”
check to sure that the Wine Cooler is level.
The rattling noise may come form the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The Wine Cooler is not level.
The Wine Cooler is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
9