User's Guide | Enabling Devices Jumbo 1526 User`s guide

For Technical Support:

Call our Technical Service Department

Monday through Friday, 9 a.m. to 5 p.m. (EST)

1-800-TEC-TOYS or 1-800-832-8697

[email protected]

Jumbo Universal Remote Control #1526

USER’S GUIDE

50 Broadway

Hawthorne, NY 10532

Tel. 914.747.3070 / Fax 914.747.3480

Toll Free 800.832.8697

www.enablingdevices.com

This universal remote allows user to easily see and push buttons to control TV, VCR, DVD, PVR, CABLE and SATELLITE RECEIVERS. It also will control the latest flat screen TV’s. The large buttons are very sensitive to touch and have different colors for different group functions. Easy to program, easy to use. Size: 18"L x 10"W x 2 ½ "H.

Requires 2 AA Batteries.

Operation:

1. Please refer to the manufacturer’s instruction manual included for programming directions for this remote, with the exception of Step

#1: Installing the Batteries. Please see below:

2. The Universal Remote requires 2 AA batteries (Not included). Use alkaline batteries only (e.g. Duracell or Energizer brand). Do not use rechargeable batteries or any other type of batteries because they supply lower voltage and the unit will not perform properly.

Never mix old and new batteries together or different brands or types together.

3. You will not be placing any batteries directly into the “G.E.” remote as this is permanently affixed to the Universal Remote. Instead, please locate the battery compartment recessed in the back of the

Universal Remote. The battery compartment cover is secured with a small screw. Use a Phillips head screwdriver to remove this screw and remove the cover. Insert the 2 AA batteries into the compartment paying careful attention to proper battery polarity.

4. Replace the compartment cover and re-secure it with the screw.

Test the unit by pressing the ON/OFF button. The red indicator light should blink. If not, change your batteries.

5. All programming will be done through the remote’s keypad on the back of this unit. When programming make sure none of the large buttons on the front become activated or depressed, doing so will prevent programming of your device.

Troubleshooting:

If you cannot get your Universal Remote to operate any of your devices, or it will not perform commands properly:

• Make sure that your batteries are fresh and installed correctly

(according to proper polarity). *

• If you are using external switches with your remote, make sure they are plugged in all the way, there should be no gaps. Test your switches on other switch adapted devices, to rule out your switches as the source of the problem.

• Read the” G.E.’s” troubleshooting section of the guide for any additional troubleshooting tips.

• Try ALL of the codes listed for your device. Many set-up codes may allow partial functionality; however, only one code will operate your device correctly.

• Make sure that you are within 6-10 feet of your device, with the remote facing the device, while programming. Make sure that you are within 15 feet of your device when using your remote.

• If the red light on the remote control does not blink when you press a key, replace the batteries with two (2) new AA alkaline batteries. Be sure to install paying close attention to proper battery polarity. *.

Care of Unit:

The Universal Remote can be wiped clean with any household multipurpose cleaner and disinfectant. We recommend Simple Green, which is a non toxic biodegradable all-purpose cleaner.

Do not submerge the unit, as it will damage the contents and the electrical components.

Do not use abrasive cleaners, as they will scratch the surface of the unit.

Rev 7/6/14