AC C6607 Pack Contents and Fitting Directions

AC C6607 Pack Contents and Fitting Directions
AC C6607 Pack Contents and Fitting Directions
Pack Contents:
The AcoustiCase™ C6607 contains 17
pieces, of 2 different acoustic materials and
an optional washable air filter.
Fitting Directions:
Fit according to the positions indicated, in the numerical order shown
from 1 to 17 . Where self adhesive is on the reverse of the materials,
remove the backing sheet and adhere lightly to clean and dust-free
surfaces, making sure that the material is correctly positioned. If you
make a mistake - it can be re-applied for a second attempt - but be
aware that excessive re-application will cause a deterioration in the
adhesive. Once well positioned, press the materials firmly into place.
Acoustic Foam
Acoustic Composite
Ensure you read the important safety information before
installing the materials.
18mm
Opt = Optional
Note Regarding Part 1 :
1. Remove the uppermost 5¼-inch
drive bay cover to help with access,
and turn the case upside down.
2. Peel back only a portion of the selfadhesive backing sheet and fit the
front section of this part first.
Once in position, fit the remainder
of the part.
15
1
Position parts 2 to 6
onto the back of drive
bay covers in unused
drive bays.
To gain access, carefully
remove front cover by
pressing tabs marked P
and lift the cover off.
9
18mm
2
Opt
10
3
16
7
4
P
Opt
5
11
6
8
P
Fitting the Optional Air Filter:
12
13
14
Opt
Opt
Opt
Opt
1. Remove the grill front
section from the case.
2. Fit the Air Filter behind
the front grills (as shown).
Remove the air filter and
wash regularly to maintain
adequate airflow. Do not use the
air filter if maximum airflow is
required for cooling purposes.
17
READ THIS BEFORE INSTALLING THE MATERIALS!
ONLY position the materials as directed in the fitting directions and as depicted in the graphics above.
DO NOT cover any necessary ventilation holes in the case with materials.
DO NOT position the rear of the case close to a permanent heat source, such as a radiator, or very close to an airflow obstruction,
such as a wall. This may inhibit air circulation required for cooling. Leave a gap at the rear of the case of at least 20cm to allow
free movement of air in and out of the case.
DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components,
especially cooling fans, disc drives and moving parts. These components require adequate space and ventilation. Whilst every care
has been taken to produce a set of materials that will be appropriate for the majority of component configurations, it is the
responsibility of the machine builder to position materials appropriately to facilitate normal functioning of internal components.
v 1.2a
PRINTED ON PAPER FROM SUSTAINABLE SOURCES
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising