- No category
3G and Dual Link equipped JVC 10-bit video processing Waveform/Vector scope
Add to my manuals
2 Pages
advertisement
17” Multi-Format LCD Monitor
DT-V17G1
3G and Dual Link equipped
SMPTE 424M/425M/372M
JVC 10-bit video processing
High operating viewing angle
Waveform/Vector scope
LTC & VITC support
Gamma selection
Various marker function
Audio level meter up to 12ch
Vector scope and waveform cannot be displayed at the same time.
HIGHLIGHTS
3G/Dual Link Equipped
1080p uncompressed digital video data transmitted at a maximum rate of 60 frames per second at 3
GB/second can be input with one
HD SDI Input. Dual Link is available through two HD SDI inputs.
3G-SDI Input Format
Following signal information can be displayed when a 3G-SDI signal comes in.
3G A-1
3G A-2
3G A-3
3G A-4
3G B-DS1
Level A mapping structure 1
Level A mapping structure 2
Level A mapping structure 3
Level A mapping structure 4
Level B data stream 1
3G B-DS2 Level B data stream 2
3G B-DUAL Level B DUAL LINK
IPS (In-Plane-Switching) LCD Panel
IPS panels with wide viewing angles and low chromatic variation ensure minimal colour change from different viewing positions.
178°
Gamma Preset
Mode
JVC offers various pre-set gamma modes
(2.2, 2.35, 2.45, 2.6) to meet your application needs.
Viewing angles
178°
Vector Scope*
Y
R
M
High-quality vector scope allows simple checking of hue and saturation of digital video signals.
Hue and saturation of colour signal
G
R
C
B
M are detected and displayed as a vector with resolution of 254 x 254.
Compatible with video, component, SDI (SD/HD), DVI
Y
G
C
B
Vector Scope
Y
G
R
C
M
B
Y
R
G
M
C
B
Y
R
G
M
C
B
Audio Level Meter
(except PC signals) input signals, and offers a double-size display** option and selection of display position or translucence functions.
Waveform*
Detects video, component (except RGB), SDI, DVI (except PC) brightness signals and displays them with resolution of 360 x 254 for
SD signals or resolution of 480 x 254 for HD signals. Besides, it is also possible to perform checks at
100
0
100
100
0 the colour signal level of each colour per screen for R/G/B,
Y/P
B
/P
R
, Y/C
B
/C
R
. Over-level function enables peak brightness
100
0
0
100
0 to be checked at a glance.
The display allows a double-size display** option, and selection of display position or translucence functions.
Waveform
Advanced Audio Level Meter
The channel number is displayed in each level bar. And, you can check the status of the audio signal at a glance for Reference Level/Over Level
0 dB, three set levels, and peak hold function.
3
4
1
2
5
6
Channel No.
Reference Level 0dB
Over Level
Peak hold
*Two display sizes cannot be displayed at the same time.
**The position is fixed for double-size display.
DT-V G SERIES
Advanced 3G/Dual-link HD monitor with IPS panel
Features
1366 x 768 resolution
Wide viewing angle 178°/178° with IPS panel
3G/Dual Link support
Circuits that deliver low latency of less than one frame
AC/DC operation
Waveform monitoring with over level function
Vector scope with selectable size and position
Advanced audio level meter up to 12 channels
Exclusive JVC image processing technology
LTC & VITC support
Selectable gamma preset modes
Wide selection of video production functions
Easy-to-operate front panel controls
Front LED dimmer function
Source ID input by ASCII code
(Red/Green/White colour linked with tally)
Information position selectable
1:1 mode
Gold-plated HD/SD SDI terminals with embedded audio
DVI-D with HDCP terminal
RS-232C, RS-485 remote
Audio speaker built-in
Rugged, adjustable stand provided
Input Format
VIDEO
Signal name
NTSC
PAL
BW(50Hz/60Hz)
480/59.94i, 60i
576/50i
480/59.94p, 60p
576/50p
640 x 480/59.94p, 60p
720/23.98p, 24p, 25p, 29.97p, 30p
720/50p, 59.94p, 60p
1080/50i, 59.94i, 60i
1080/50p, 59.94p, 60p
1035/59.94i* 3 , 60i* 4
1080/23.98p, 24p, 25p, 29.97p, 30p
1080/23.98psf, 24psf, 29.97psf* 3 , 30psf* 4
1080/25psf
Video
✓
✓
✓
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
Input terminals
COMPO. (Analog component)* 1
E. AUDIO SDI (IN 1, IN 2)*
SD/HD (1.5G) 3G SDI
2
DUAL LINK
̶
̶
̶
✓
✓
✓
✓
̶
✓
✓
✓
̶
✓ * 3 * 4
̶
̶
̶
✓
✓
̶
̶
̶
✓
✓
✓
̶
✓
̶
̶
̶
̶
̶
̶
̶
̶
✓
✓
✓
✓
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
̶
✓
✓
̶
✓
✓ * 3 * 4
̶
✓
✓ * 3 * 4
̶
✓
✓
✓
✓
✓
✓
DVI-D (HDCP)(Digital component/digital RGB)
̶
̶
̶
✓
✓
✓
✓
✓
̶
✓
✓
✓
✓ *
✓
̶
̶
3 * 4
*1: Analog component signals are compatible with Y on sync signals.
*2: Compatible with EMBEDDED AUDIO signals.
*3: The signal is recognized as 1080/60i, and the status is displayed as “1080/60i.”
*4: The signal is recognized as 1080/59.94i, and the status is displayed as “1080/59.94i.”
17” Multi-Format LCD Monitor
HD/SD SDI
Gold-plated
3G/Dual link ready
Specifications
Model
Type
Screen Size
Aspect Ratio
LCD Panel
Effective Screen Size (W x H)
Pixels
Display Colours
Viewing Angle
Brightness
Contrast Ratio
Response Time (G to G)
Horizontal/Vertical
Frequency (PC signals)
Applicable Standard
Audio Output
Environmental Conditions
Power Requirements
Rated Current
Horizontal
Vertical
Horizontal
Vertical
Operating temperature
Operating humidity
Storage temperature
DT-V17G1
Multi-format HDTV/SDTV LCD monitor
Type 17 wide format
16:9
17" wide, active matrix TFT
372.9 x 209.7. mm (14-11/16" x 8-1/4")
1366 x 768 (W-XGA)
16.77 million
178˚
178˚
350 cd/m 2
900: 1
Rise time 8ms / Decay time 9ms (TYP)
31.469 kHz to 75.000 kHz
48 Hz - 65 Hz
Depending on the signal within the range of these frequencies, some signals may not be displayable in which case, "Out of range " is shown.
3G SDI (Ready) : SMPTE424M/SMPTE425M
DUAL LINK HD SDI (Ready) : SMPTE372M
HD SDI: BTA S-004C, SMPTE292M
SD SDI: ITU-R BT.656: 525/625, SMPTE259M: 525
EMBEDDED AUDIO: SMPTE299M, SMPTE272M
Internal: 1.0 W + 1.0 W (L/R)
5°C to 35°C (41°F to 95°F)
20% to 80% (non condensing)
-20°C to 60°C (-4°F to 140°F)
AC 120/220-240 V, 50/60 Hz/DC 12 – 17 V
1.2 A (AC 120 V) / 0.8 A (AC 220 – 240 V)
5.0 A (DC 12 – 17 V)
Dimensions (WxHxD) excluding protrusions)
Weight
With desktop stand
Without stand
Including stand
Excluding stand
430 x 349.8 x 199 mm (17" x 13-7/8" x 7-7/8")
430 x 309 x 102 mm (17" x 12-1/4" x 4-1/8")
8.6 kg (18.9 lbs.)
Provided Accessories
6.8 kg (15.0 lbs.)
AC power cord, power cord holder, screw x 2 ( for power cord holder), Ferrite core x 1 ( for external battery)
Input/Output Terminals
Video
Audio
External Control
HD/SD SDI (IN1)
HD/SD SDI (IN2)
HD/SD SDI (OUT)
DVI-D (HDCP)
COMPO.
(Y, P
B
VIDEO
/B-Y, P
AUDIO IN
R
/R-Y)
Digital signal input (compatible with EMBEDDED AUDIO/
DUAL LINK): Auto detection, 2 line, BNC x 2
Digital signal output
(compatible with EMBEDDED AUDIO)
1 line (switched out), BNC connector x 1
DVI-D signal input (compatible with HDCP):
DVI-D connector x 1 (compatible with DDC2B)
Analogue component signal input/output: 1 line, BNC x 6
Video signal: Y: 1 V (p-p), 75 ohms,
P
B
/B-Y, P
R
/R-Y: 0.7 V (p-p), 75 ohms
* The input (IN) and output (OUT) terminals are bridgeconnected
(auto termination)
Composite video signal input/output: 1 line,
BNC x 2, 1 V (p-p), 75 ohms
(IN and OUT are connected with a bridge connection)
(auto termination)
Analogue audio signal input:
1 line, RCA x 2, 500 mV (rms), high impedance
AUDIO MONITOR OUT Analogue audio signal output: 1 line, RCA x 2, 500 mV (rms)
MAKE/TRIGGER RJ-45 x1 (8-pin)
RS-485
RS-232C
RJ-45 x2 (IN/OUT)(8-pin)
D-sub(9-pin) x1
Computer Signals
Signal name
VGA60
WVGA60
SVGA60
XGA60
WXGA (1280)
WXGA+60* 5
SXGA60*1
WSXGA+60* 5
UXGA60* 5
WUXGA60* 5
720/60p
1080/60p*
720/50p
5
1080/50p* 5
Horizontal
640
Resolution
852
800
1024
1280
1440
1280
1680
1600
1920
1280
1920
1280
1920
Vertical
480
480
600
768
768
900
1024
1050
1200
1200
720
1080
720
1080
Dimensions
430 (17)
102 (4-1/8)
56 (2-1/4)
1.3 (1/16)
Frequency
Horizontal (kHz)
31.5
Vertical (Hz)
59.9
31.5
37.9
48.4
47.8
59.9
60.3
60.0
60.0
55.9
64.0
65.2
75.0
74.0
45.0
67.5
37.5
56.25
60.0
60.0
60.0
60.0
60.0
60.0
60.0
50.0
50.0
3 (1/8)
Scan system
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
Non-interlace
*5: When signals come in, thin lines will become obscured because their signal resolution is higher than the screen resolution.
When a preset signal comes in, the signal format is shown on the status display. For other signals, the resolution is shown.
VESA mounting holes
(Size: 4-M4, depth: 10 mm)
100
DVI-D
Audio
In/Out
Speaker
Stereo
RS-232C
RS-485
In/Out
Make/ ttrigger
Vector scope
Waveform monitoring
Gamma preset
Area marker
Safety marker
Tally lamp
Time code
CRC error
Audio level meter
Source ID
display
1:1 mode
I/P mode
Stand
(Tilt & height adjustable)
Rack mount
(Option)
VESA
Carrying handle
Power
AC/DC
Rear Panel
Option
RK-C17D2 (Rack mount adapter)
Front Panel
240 (9-1/2)
18 (3/4)
199 (7-7/8)
* at the higher position
** at the lower position
Unit: mm (inches)
Simulated TV picture E. & O.E. Design and specifications are subject to change without notice.
All company names and product names may be trademarks or registered trademarks of their respective owners. Any rights not expressly granted herein are reserved.
Copyright © 2010, Victor Company of Japan, Limited (JVC). All Rights Reserved
Printed in Japan
ICN-0391
“JVC” is the trademark or registered trademark of Victor Company of Japan, Limited.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement