Holmes DTU [0501716] [10/2009]

Holmes DTU [0501716] [10/2009]
OWNER'S MANUAL
DTU
PARTS
NOTE: MANUAL including SPECIFICATIONS, subject to change without notice.
All ratings specified are based on structural factors only,
not vehicle capacities or capabilities.
Miller Industries Towing Equipment Inc.
8503 Hilltop Drive
Ooltewah, Tennessee 37363
Phone (423) 238-4171 • FAX (423) 238-5371
FORM NO. 0501713
10 / 2009
PRICE $25.00
LIMITED WARRANTY
MILLER INDUSTRIES TOWING EQUIPMENT INC., hereinafter referred to as MILLER, warrants to the original
purchaser that each new MILLER wrecker or other MILLER products will be free from defects in material and
workmanship for a period of twelve (12) months from date placed in service, but in no event shall such warranty
period exceed twenty-four (24) months from date of manufacture by MILLER. The purchaser must promptly
notify MILLER in writing of any failure in material or workmanship. In no event shall MILLER accept such
notification later than twenty-four (24) months from date of delivery or twelve (12) months from date placed in
service, whichever is earlier.
MILLER's obligation under this warranty, statutory or otherwise, is limited to the repair or replacement at the
MILLER factory, or at a point designated by MILLER, of such part or parts as shall appear upon inspection
by MILLER to be defective in material or workmanship. New or remanufactured parts will be used for any
replacement at MILLER's option. This warranty is not transferable. This warranty does not obligate MILLER
to bear the cost of labor or transportation charges in connection with the repair or replacement of any parts
found to be defective, nor shall it apply to a product upon which repairs or alterations have been made unless
authorized by MILLER.
EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, MILLER MAKES NO OTHER WARRANTY,
EXPRESS OR IMPLIED, AND HEREBY DISCLAIMS ALL OTHER WARRANTIES INCLUDING, BUT NOT
LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. MILLER shall in no event be liable for claimed downtime, claimed loss of profits or goodwill, or
any other special, incidental, indirect, or consequential damages concerning or relating to any product or parts,
whether based on negligence, strict liability, breach of contract, breach of warranty, misrepresentation or any
other legal theory, regardless of whether the loss resulted from any general or particular requirement which
MILLER knew or had reason to know about at the time of sale.
MILLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, AS TO THE FINISHED PRODUCTS
MANUFACTURED OR SUPPLIED BY ANOTHER MANUFACTURER AND SUPPLIED BY MILLER TO
PURCHASER, including, but not limited to, any vehicle to which a MILLER product may be affixed or any accessories
or wire rope, and MILLER EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE AS TO SUCH EQUIPMENT OR PRODUCTS. This language
shall in no way affect or diminish the rights of the purchaser to rely on such warranties as are extended by
such manufacturers or suppliers. MILLER shall, to the extent permitted under applicable law, pass on to the
purchaser such manufacturer's or seller's warranty.
MILLER, whose policy is one of continuous improvement, reserves the right to improve its products through
changes in design or materials as it may deem desirable without being obligated to incorporate such changes
in products previously sold. This warranty is not intended to cover or include the following items, which are set
forth by way of example and not limitation:
A.Normal deterioration of trim, paint, lettering, and appearance items due to wear or exposure to weather,
road conditions, road treatments, etc.
B.Any damage or defect due to accident, misuse, abuse, improper or unauthorized repairs, failure to provide
reasonable and necessary maintenance, or uses for which the equipment was not designed or intended.
C.Alterations or modifications that affect performance, operation or reliability.
D.Normal maintenance parts including, but not limited to, wear pads, bushings, wire rope, mud flaps,
fenderettes, light bulbs, hydraulic oil, filters, and tow sling belts.
IT IS EXPRESSLY UNDERSTOOD THAT MILLER MAKES NO IMPLIED WARRANTY THAT MILLER
PRODUCTS SHALL BE FIT FOR THE PURPOSE OF LIFTING OR MOVING PEOPLE OR FOR ANY OTHER
IMPROPER USE.
Miller Industries Towing Equipment Inc.
8503 Hilltop Drive
Ooltewah, Tennessee 37363
Telephone (423) 238-4171
SERIAL NUMBER
OWNER, USER AND OPERATOR:
We appreciate your choice of our towing and recovery unit for your application. Our number one priority is
user safety which is best achieved by our joint efforts. We feel that you can make a major contribution to
safety if you, as the equipment owner and operator:
1.Comply with Federal, State, and Local Regulations.
2.Read, Understand, and Follow the Instructions in this Manual.
3.Use Good, Safe Work Practices in a Common Sense Way.
4.Only have Authorized and Trained Personnel performing maintenance on the Towing and Recovery
Unit.
© 2009 MILLER INDUSTRIES TOWING EQUIPMENT INC. All rights reserved. Reproduction or use, without express permission, of editorial or
pictorial content, in any manner, is prohibited.
i
TABLE OF CONTENTS
It is assumed by the manufacturer that the Owner/Operator has a thorough knowledge of the accepted and lawful
retrieval and towing methods as dictated by his city, county or state. The manufacturer rejects any liability claim that
may result from the incorrect or unlawful application of its equipment.
Section I - PARTS
SUBFRAME ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-2 & I-3
BOOM ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-4 & I-5
UNDERLIFT ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-6 & I-7
DTU TOWER & UNDERLIFT HYDRAULICS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-8 & I-9
PUMP, VALVE & FILTER HYDRAULICS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-10 & I-11
OPTIONAL WINCH HYDRAULICS & AIR FREE SPOOL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I-12 & I-13
ii
Section VI - PARTS
This Section is provided by the manufacturer for the purpose of ordering any component part of the HOLMES DTU
that may be required when part replacement is necessary. Be certain to use only original equipment replacement
parts for warranty purposes as well as for keeping your unit in its original state and optimum operating capacities.
When ordering replacement or spare parts be sure to provide the following information to the manufacturer’s Parts
Department.
1.
2.
3.
4.
5.
6.
7.
Manual Number & Date of Publication
Manual Page Number
Page Title
Reference Number of Part Desired
Part Number
Part Description
Quantity of Part Desired
Providing this information will help ensure that the correct parts will be delivered to you in an expedient manner
without delay. Should additional information be required for repair or replacement of certain components, contact
your Wrecker Manufacturer Authorized Representative.
The Manufacturer reserves the right, without notice or obligation, to improve or modify their products, which may
change the specifications, models and feature availability.
I-1
Section I - PARTS (cont'd)
SUBFRAME ASSEMBLY
I-2
Section I - PARTS (cont'd)
SUBFRAME ASSEMBLY
I-3
Section I - PARTS (cont'd)
BOOM ASSEMBLY
I-4
Section I - PARTS (cont'd)
BOOM ASSEMBLY
I-5
Section I - PARTS (cont'd)
UNDERLIFT ASSEMBLY
I-6
Section I - PARTS (cont'd)
UNDERLIFT ASSEMBLY
I-7
Section I - PARTS (cont'd)
DTU TOWER & UNDERLIFT HYDRAULICS
I-8
Section I - PARTS (cont'd)
DTU TOWER & UNDERLIFT HYDRAULICS
I-9
Section I - PARTS (cont'd)
PUMP, VALVE & FILTER HYDRAULICS
I-10
Section I - PARTS (cont'd)
PUMP, VALVE & FILTER HYDRAULICS
I-11
Section I - PARTS (cont'd)
DTU WINCH HYDRAULICS & AIR FREE SPOOL
I-12
NOTES
NOTES
NOTES
Miller Industries Towing Equipment Inc.
8503 Hilltop Drive • Ooltewah, Tennessee 37363 • (423) 238-4171
www.millerind.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement