Design Engineering, Inc. Protect-A-Boot Installation Instructions

Design Engineering, Inc.
604 Moore Road
Avon Lake, OH 44012
Installation Instructions
DEI Protect-A-Boot™
PART NO. 010501 through 010532 and PART NO. 010701 through 010732 in kits
KIT CHECKLIST
2 or 8
12345-
1 of 1
Protect-A-Boots
NOTE
Protect-A-Boots are designed for use on most spark plug
boots whether straight or 90degree.
DIRECTIONS
Remove spark plug wire from spark plug.
Feed the large end of the Protect-A-Boot over the sparkplug boot and continue until the
small end of the Protect-A-Boot meets the open end of the spark plug boot.
Reinstall the spark plug wire on the spark plug.
Again, watch that the Protect-A-Boot is not in direct contact with the header or exhaust
manifold. The product’s longevity could be greatly compromised.
Repeat steps for remaining ignition wires.
www.DesignEngineering.com
800-264-9472
v02.08
INS025
">