High Power DC to DC Converter

High Power DC to DC Converter
TP-DCDC - HP
DATA SHEET
High Power DC to DC Converter
Features








Input Voltage 12VDC, 24VDC or 48VDC
Passive POE Output voltage 24VDC or 56VDC
IEEE802.3at Model Available
High Power up to 35W
Integrated POE Inserter
Low self consumption power
Short Circuit, Over Current and Reverse/Over Voltage Protection
High Temperature Operation
TP-DCDC-HP
Applications
 12V, 24V and 48V Battery Systems
 Wireless Access Points and Client Devices
 IP Phone and Security Camera Systems
Description
The TP-DCDC-HP Series of DC to DC converters offered by Tycon Power Systems are a low cost and high reliability
solution for those requiring 24VDC or 56VDC Power Over Ethernet voltage from a 12V, 24V or 48V battery system.
They have an integrated POE injector. Passive POE and 802.3at models are available. They have two inputs for
connecting 2 power sources, like a primary and backup power source.
They accept data-in to a shielded RJ45 Jack and provide data-out and POE power on the shielded RJ45 output jack.
They work by supplying power on the unused Ethernet pins 4,5(V+) and 7,8(V-). They have various protections for
surge, short circuit and overload. The units have a power output of up to 35W. The input and output are isolated so the
units can accept minus voltage on input and can be wired for positive voltage on the output for those systems which are
negative voltage based.
If the remote device does not support power over Ethernet, splitters (POE-SPLT-S) are available to split the data and
DC voltage at the remote device. If the remote device requires reverse voltage the POE-XOVER-S cable can be used.
Device Pinouts
RJ-45 Input (Data Only)
RJ-45 Output (Data & Power)
Pin
Symbol
Description
Symbol
Description
1
2
3
4
5
6
7
8
RX+
RXTX+
NC
NC
TXNC
NC
Data Receive(+)
Data Receive(-)
Data Transmit(+)
No Connection
No Connection
Data Transmit(-)
No Connection
No Connection
RX+
RXTX+
+Vdc
+Vdc
TX-Vdc
-Vdc
Data Receive(+)
Data Receive(-)
Data Transmit(+)
DC power(+)
DC power(+)
Data Transmit(-)
DC power(-)
DC power(-)
TP-DCDC - HP
Page 2
Specifications
Input Voltage
TP-DCDC1224-HP
TP-DCDC2448-HP
TP-DCDC4824-HP
TP-DCDC4848-HP
TP-DCDC4848D-HP
+/- 10VDC to
15VDC
+/- 18VDC to
36VDC
+/- 36VDC to
72VDC
+/- 36VDC to
72VDC
+/- 36VDC to
72VDC
DC Input Connector
Removeable Screw Type Compression Wire Terminal (12 AWG Max)
POE Specification
Passive
Output Voltage (+/-2.5%)
Data in & Data/POE
Output Connector
Output Current (max)
Output Power (max)
24VDC
56VDC
IEEE 802.3at
24VDC
56VDC
0.5A
0.625A
RJ45 (Shielded)
1.46A
0.5A
1.25A
35W
30W
Self Consumption Power
2W
Efficiency (min)
75%
Line Regulation
1%
Load Regulation
5%
Ripple
1%
Noise
1%
EMC Standards
35W
FCC Class B NE55022 Class B
Safety Standards
UL1950, CSA 22.2 &TUV EN60950
Operating Temperature
-30 to +60°C (-22 to +140°F)
Operating Humidity (RH)
5% - 90%
Storage Temperature
-40 to +80°C (-40 to +176°F)
125 x 75 x 38mm (4.9 x 3 x 1.5”)
Dimensions (LxWxH)
Weight
Notes:


56VDC
300g (10.6oz)
DC Input Connector
All shipments F.O.B. Bluffdale, UT 84065
Tycon Power Systems Power Sources carry a 1 year warranty
System Ordering:
TP-DCDC-1224-HP +/- 10-15VDC IN 24VDC OUT, 35W DC to DC Converter with POE Inserter
TP-DCDC-2448-HP +/- 18-36VDC IN 56VDC OUT, 30W DC to DC Converter with POE Inserter
TP-DCDC-4824-HP +/- 36-72VDC IN 24VDC OUT, 30W DC to DC Converter with POE Inserter
TP-DCDC-4848-HP +/- 36-72VDC IN 56VDC OUT, 30W DC to DC Converter with POE Inserter
TP-DCDC-4848D-HP +/- 36-72VDC IN 56VDC OUT, 35W DC to DC Converter with 802.3at POE Inserter
For further information contact:
Tyconpower.com
14641 S 800 W Suite A
Bluffdale, UT 84065
PH: 801-432-0003
FAX: 801-618-4220
TP-DCDC-HP Spec Rev 5 30-Jan-14
Specifications Subject to Change Without Notice
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement