Water Pump Installation Instructions

Water Pump Installation Instructions
Water Pump Installation Instructions.
1.
Check pump package for following items.
2.
Remove lower rear panel of saw
3.
Remove ignition switch
4.
Pull ignition switch out and separate white wires
5.
Connect bullet clamp-on receptacle to white wire
6.
Detach hose from blade guard , pull out, and cut approx. 9 in from rear of saw.
7.
Attach loose part of hose to outlet fitting of water pump and install pump. Attach ground wire when
installing pump to mounting screw.
8.
Attach other part of hose to inlet of water pump
9.
Insert bullet connector into bullet clamp-on receptacle
10. Re-install ignition switch, and install water pump switch. Water pump will be shipped in the off position
which is to point down when installed.
11. Re-attach water hose to blade guard.
12. Secure loose wires away from drive chain and re-install rear panel.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement