LockIt
™
Cable Adapter Tether Kit • Installation Guide
The LockIt Cable Adapter Tether provides a simple method to link cables and adapters together to prevent them from being stolen or lost. To install the tether, follow these instructions and see the figures at right.
1. Thread one end of the nylon coated wire through a heat shrink wrap ( Ä ) and the metal loop sleeve ( about 2 inches (51 mm) of free wire.
Å ), leaving 1a
1b
2. Loop the free end of the wire around the first cable to be secured and thread the end of the wire back through the metal loop sleeve ( b ).
2.0" (51 mm)
2
3. Tighten the wire ( c ) until about 1/4 inch (6.4 mm) of the short end extends past the metal sleeve ( of space between the wire and the cable (
Ñ
Ö ).
). To avoid damaging the cable, allow about 1/8 inch (3.2 mm)
3
3a
1/4" (6.4 mm)
4. Crimp the metal loop sleeve with a pair of pliers to secure the wire in place ( d ).
3b
1/8" (3.2 mm)
4
5
5. Slide the wrap over the metal loop sleeve ( heat it to shrink it in place.
e ) and
6. Repeat steps 1-5 to secure the other end of the wire to a second cable ( f ).
6
© 2012 Extron Electronics All rights reserved. www.extron.com
68-2284-01 Rev A 07 12