3000ED/8000ED Exit Devices Installation Instructions

3000ED/8000ED Exit Devices Installation Instructions
PRODUCT MUST BE INSTALLED
ACCORDING TO ALL APPLICABLE
BUILDING AND LIFE SAFETY CODES
CONTROL SWITCH (N.O.)
(EX. TOGGLE SWITCH OR TIMER WITH MAINTAINED CONTACTS)
DRY CONTACTS !
4603
2-AMP RECTIFIER
HINGE
EDGE OF DOOR
RED
X
120 VAC
LINE
VOLTAGE
X
WHITE(+)
RED
4605/4606--24VAC
40 VA TRANSFORMER
D1
RED
24 VDC
BLACK (-)
EL ELECTRIFIED
EXIT DEVICE
X
X
BLACK
NOT SUPPLIED
MAY USE 1N4004
TO PREVENT ARCING
IN SWITCH
4612 WIRE
TRANSFER
REFER TO EXIT DEVICE
TEMPLATE FOR BAR
HEIGHT
ELECTRIC DOGGING WIRING SCHEMATIC FIG. 1
BLUE
BLUE (N.O.)
HINGE
EDGE OF
DOOR
EXIT DEVICE
MOUNTING HOLES
(REFER TO EXIT
DEVICE TEMPLATE)
3/8" DIA. FOR WIRING
ACCESS. TO BE
LOCATED AND
PREPPED AT
INSTALLATION.
REFER TO EXIT DEVICE
TEMPLATE FOR BAR
HEIGHT
DOOR PREPARATION FIG. 2
www.adamsrite.com
Phone: 800-626-7590
800-872-3267
Fax: 866-582-4641
800-232-7329
Rev. E
A single pole single throw monitor switch
is added to the holding magnet to indicate
when the unit is unlatched and electrically
dogged. Switch outputs can be used to signal
automatic door operators, monitor panels, fire
control panels etc.
FIG. 3
INSTALLATION INSTRUCTIONS
3000ED/8000ED EXIT DEVICES,
80-0180-269
LATCH MONITOR SWITCH
ECN: 11955C
Date: 07-18-12
Page 1 of 1
Appvd: MP
Date: 07-19-12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising