SERVICE INFORMATION
The instructions in this booklet serve as a guide for routine operation and maintenance. For further
Information contact your local authorized dealer/distributor
BEAM ALLIANCE LED/LCD ICON CHART
SYMBOL
g
10
DESCRIPTION
AVAILABILITY
MEANING
ACTION REQUIRED
ON/OFF Button
Standard
Turns power unit on or off
None
Navigation Buttons
On select models
These buttons are located below
the display screen. Use to modify
time or reset empty bucket indicator
Scroll through using Left ( < ) or
Right ( > ) buttons to appropriate
icon. When the appropriate
selection is highlighted, hold the
Enter (
) button down for 5
seconds
Clock
On select models
A digital clock is located on the top
left corner of the display screen of
the power unit
You can choose from either a 12
or 24 hour clock. To set time, use
the (<) and (>) buttons to arrive at
the correct time. Press Enter (
)
when your selections are complete
Communication Link
On select models
The communication link icon
appears at the top of the power
when the hose connection into the
inlet valve is complete and the hose
handle is communicating with the
power unit
None
Screen Saver
On select models
When the power unit wakes from
sleep mode, the screen saver icon
will appear for 2-3 seconds before
disappearing and other icons will
appear
None
Variable Speed Indicator
On select models
When the power unit is on, the
fan blades on the screen will
spin relative to the speed/suction
indicated on the hose handle
None
Empty Bucket Indicator
On select models
The empty bucket indicator is
timed to remind you to empty your
dirt bucket. The power unit will
communicate with the hose handle
signalling fan blades to flash red
Empty dirt bucket and reset the
system by pushing one of the two
reset buttons and holding for 5
seconds
Performance Bars
On select models
3 - 4 bars indicate the system is
performing at the optimum level.
Performance levels will change
depending on the variable speed
settings and during the use of
specialty attachments
Check for blockage if performance
bars fluctuate under normal
vacuuming conditions
Flashing Performance Bars Alert
On select models
When 2 bars or less are illuminated,
the airflow of your power unit is
exceptionally restricted. The power
unit will communicate to the hose
handle and flashing red fan blades
will display
Check to ensure the dirt bucket
is not overloaded. Check for
blockages in the system. Check for
motor wear (contact an authorized
service technician)
Motor Fault Indicators
Standard
Indicates a system fault or
malfunction. This symbol may
occur due to one of the following:
1) Maximum system run time
exceeded; 2) Electronics problem;
3) Power surges; 4) Motor failure; 5)
Mechanical failure
Turn on and off the power unit. This
may reset the system. If this fails,
unplug the power unit and call an
authorized technician
Error Codes
On select models
Error codes defined:
ER 1: Under current
ER 2: Over current short
ER 3: 30-minute time out
ER 4: Over current long
ER 5: Line error or off current
Turn off and unplug power unit
and call an authorized technician.
For further detail on error codes,
contact your authorized service
dealer
or
or
">
