Husky Liners Installation Instructions 54371

Husky Liners Installation Instructions 54371
PART NO.
5437
DODGE RAM DUAL REAR FLAT MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
Package Contents
• Short Phillips screwdriver
• Driver & passenger side rear mud guard
• Center punch
• #10 screw (qty. 12)
• Drill / 1/8” drill bit
• Washers (qty. 12)
• U-Clip (qty. 4)
• Instruction sheet
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
1.
2.
3.
4.
Clean and degrease the mud guard location area on the fender before installation.
Remove existing fasteners from locations A and E (Figure 1).
Attach mud guard at locations A and E with #10 screw #10 screw and washer, check fit and level before tightening.
Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations B and C and attach with a #10
screw and washer (Figure 1).
5. Using mud guard as a template, mark and drill 1/8” holes at locations D and F and attach with a #10
screw and washer thru mud guard, fender liner and into a U-Clip (Figure 1).
NOTE: The U-Clip is used as a nut and placed on the backside of the fender liner - DO NOT clip U-Clip over liner.
NEED A LOGO FOR YOUR NEW MUD GUARD? TRY AN INTERNET SEARCH FOR
“EMBLEM” ON E-BAY, AMAZON OR YOUR FAVORITE AUTOMOTIVE SITE.
5437 Dodge Dual Flat #F7AD8.doc
Rev: 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement