C3405

C3405
INSTALLATION INSTRUCTIONS
P/N: C3405
9” FORD AXLE HOUSING BRACE
To combat flex, Competition Engineering has designed the 9” Ford Axle Housing Brace. This two-piece
brace welds directly to the rear housing, triangulating the main housing with the axle tubes to eliminate
any flex. By eliminating the flex, you increase the amount of power going to the tires and improve your
ET's.
PARTS LIST
1) Driver’s Side Brace
1) Passenger Side Brace
INSTALLATION
1. Trial fit the braces to the housing. If necessary trim the edges to fit using an angle grinder and a
file.
2. Grind the area that the braces will be welded to ensure good penetration.
3. Tack weld the part to the housing in several places before beginning final welding.
4. In order to limit the amount of distortion, do not weld in one continuous bead. Instead weld in oneinch increments alternating from side to side.
5. For maximum effectiveness the brace should be welded on all areas that contact the housing.
6. We highly recommend that you use an alignment bar to prevent the tubes from distorting during
the weld process.
For Technical Assistance, call Competition Engineering's Tech Line at
(203) 458-0542, 8:30am-5:00pm Eastern Time
COMPETITION ENGINEERING
80 Carter Drive • Guilford, CT 06437
Phone: (203) 453-5200 • Fax: (203) 453-6906
REV. C
082214
Visit Us At www.competitionengineering.com
C3405INST
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement