Quick Start Guide - LW2232 Wireless Security Camera

Quick Start Guide - LW2232 Wireless Security Camera
W IR E LE S S DIGITAL SEC U R ITY C A MER A S
LW2232
QUICK START GUIDE
Getting Started
A. Installing the Cameras
Mount the camera to the wall or
ceiling using the included screws.
1
2
Cable Notch
NOTE:
For outdoor use, installation in a
sheltered location is recommended.
This system comes with the
following components:
2x
1x
2x
2x
3x
2x
2x
wireless cameras
wireless receiver
antennas for cameras (pre-attached)
antennas for receiver (pre-attached)
power adapters (for cameras and receiver)
mounting kits for cameras
double-sided tape for receiver
If you run the cables
along the wall / ceiling,
you must run the cable
through the cable notch
on the base. This will
keep the camera base
flush to the wall /
ceiling when mounted.
Loosen the two
thumbscrews (1,2)
and the adjustment
ring (3). Adjust the
angle of the camera
until the desired view
is set. Tighten the
thumbscrews and the
adjustment ring to
secure the camera
position.
1
2
3
Connect the camera power
adapter to the camera.
Connect power
adapter to a 120V
AC power outlet.
3
Power cables are only weatherproof when fully
inserted at the connection point. Power cables not
to be submerged in water.
B. Installing the Receiver
1
2
OPTIONAL
Use the included double-sided tape to securely
attach the receiver to a flat surface.
3
Connect the receiver power
adapter to the receiver.
Connect the power adapter
to a 120V power outlet.
Installing Multiple Wireless Cameras
Plug both BNC cables from the wireless receiver
into your DVR.
ATTENTION:
Make sure to first connect and power
on the cameras before powering on the
receiver. This will ensure a proper
connection.
Installation Tips
Before you permanently install your cameras:
When installing multiple digital wireless security
cameras in the same environment maintain at least
4” / 10cm between the receivers to optimize camera
performance.
NOTE: It is not recommended to install more than 4 digital wireless
security cameras (2 receivers) in the same environment to
maintain optimal video frame rate performance.
Plan where and how they will be
positioned.
Determine where you will route the
cable that connects the camera to the
power adapter.
Verify the camera’s performance by
observing the image on a monitor when
the camera is positioned where it will be
permanently installed.
Avoid installing cameras in locations that
require the wireless signal to pass through
cement, concrete and metal structures. This will
reduce the transmission range.
Need to extend the wireless range?
See instruction manual for further details.
REGISTER NOW TO RECEIVE
3-MONTHS EXTENDED WARRANTY
It’s all on the Web
Scan the QR code or go to the
address below for the complete
user’s guide.
lorex.ca/LW2230
www.lorextechnology.com/warranty
LW2232_Quick Start Guide_R3
www.lorextechnology.com
Page 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement