Moen DN7903BN Ashville Double Robe Hook in Spot Resist Brushed Nickel Installation guide

Ashville™ Technical Specification
Robe Hook
Stock Numbers:

DN7903BN – Robe Hook
Brushed Nickel Finish

DN7903BRB – Robe Hook
Mediterranean Bronze Finish

DN7903CH – Robe Hook
Chrome Finish
Materials:
Robe Hook post is die cast from
highest quality zinc alloy (Zamac).
DN7903
Dimensions:
Installation Instructions:
1. Remove mounting posts from the product assemblies by
loosening each setscrew.
2. Position the mounting plate on the wall at desired location with
“UP” facing you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into
each hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the
setscrew facing down. Tighten setscrew.
Cleaning Instructions:
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Stock Number:______________________Robe Hook
By Creative Specialties
2 5 3 0 0 A L MO E N D R I V E  N O R TH O L MS TE D , O H 4 4 0 7 0
C O R P O R A TE H E A D Q U A R TE R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9  F A X: ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N TE R N A TI O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0  F A X: ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S TO ME R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6  F A X: ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . MO E N . C O M
Copyright Creative Specialties International
Literature # BA1585