The Loop Pad is for use with hearing aids that... "MT" (Loop pickup) facility. The Loop Pad is used... Description

The Loop Pad is for use with hearing aids that... "MT" (Loop pickup) facility.  The Loop Pad is used... Description
Description
LA1xx / LA2xx Amplifier Types
The Loop Pad is for use with hearing aids that have the "T" or
"MT" (Loop pickup) facility. The Loop Pad is used with all
types of Sarabec Loop Amplifiers, as an alternative to the
standard Loop Cable around the room. The pad can be placed
either under the user's seat cushion or over the back of an
armchair enabling the user to be free of any connecting wires.
The Loop Pad can also be used with other suitable Loop
Amplifiers that can accept a 3 Ohm load.
Loop Amplifier
Model: LA200
Aux In
DO NOT OPEN
No user serviceable parts inside.
Loop Cable
Left
Sarabec Ltd., Middlesbrough
Made in UK
Microphones
Serial No:
Right
0.5 - 1.5 Ohms
230 Volt AC Mains
Power Lead Socket
B
A
230V~ 50Hz 20 VA Max
Loop Pad
connectors
Loop Pad
Connect one wire of the lead to the right hand terminal (RED)
and the other wire in the lead to the left hand terminal
(BLACK).
Instructions for use
Red
Black
MODEL : Loop Amplifier LA2c
Part No : 125-900
220 - 240 V ~ 50Hz 20 VA
WARNING : This Amplifier must be earthed
Red
LA2x / LT1 Amplifier Types
Black
Place the amplifier in a convenient position near to the
television. Place the loop pad in a suitable position on the chair
to be used when watching TV. Lay the connecting lead from
the Pad to the back of the amplifier. Make sure that the
connecting lead is kept out of the way to prevent injury or
obstruction.
Serial No:
DO NOT REMOVE COVERNo user serviceable parts inside
Loop Cable 1 - 2.5 OHMS
Made in UK by Sarabec Ltd. Middlesbrough 01642 247789
Aux. Input
220-240 Volt AC
Mains Lead
To connect the cable to the back of the amplifier, see the
following diagrams for specific amplifier types.
In all cases, when a terminal is pushed, a hole will appear, push
the wire into the hole, making sure that only the wire and not the
plastic insulation goes in, then release the terminal.
Loop Pad
Loop Pad connectors
Connect one wire of the lead to the left hand terminal (RED)
and the other wire in the lead to the right hand terminal
(BLACK). No wires should be placed in the inner pair of
terminals.
is a mark of Sarabec Ltd.
Listening Position
Sarabec Ltd 110-053.001 0704 Loop Pad.doc©
®
When listening to the loop system, the user may find that
varying their position in the chair will change the reception.
The loop pad should be adjusted for position so that satisfactory
sound levels are obtained.
Loop Pad
Sarabec Limited 15 High Force Road
Middlesbrough TS2 1RH UK
Telephone (01642) 247789
Fax (01642) 230827 Text (01642) 244148
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement