BAND-IT Q Band Q Clip Installation Instructions

BAND-IT Q Band Q Clip Installation Instructions
Installation
Instructions
Q-Band
1. Cut Q-Band to length, allow 2-3
inches of excess material for tool
to grip the band.
2. Fully insert one end of Q-Band
into self-locking lower end of QClip with ribs facing up until it
stops.
3. Wrap Q-Band around object and
push loose end through higher side
of Q-Clip. Pull though at least 2-3
inches for tool to grip.
4. Tighten with Q-Gun.
5. Cut end flush for a lower profile
or leave long to re-use.
7. To loosen or undo, lift the back
locking section off of band ribs to
release.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
WWW.CABLEJOINTS.CO.UK
THORNE & DERRICK UK
www.BAND-IT-IDEX.com
TEL 0044 191 490 1547 FAX 0044 477 5371
TEL 0044 117 977 4647 FAX 0044 977 5582
WWW.THORNEANDDERRICK.CO.UK
Page 1 of 1
Document # P13687 rev. B
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement