- No category
advertisement
◉
Touch to zoom
Your Current TV Remote Can Control Your SoundBase® System. After following the steps outlined in this guide, your cable remote will adjust the volume output from your SoundBase system. Please Note: If you have a DirecTV remote control, use the DirecTV remote guide included along with this instruction sheet. remote control. To insure accuracy, the learning routine records each button’s commands twice, then confirms a successful recording. ZVOX® Audio has specific instruction sets available for a variety of popular remote controls. These instructions provide an alternate method for configuring your SoundBase to respond to your preferred remote control. If you can not easily teach the SoundBase to respond to your preferred remote control, please contact ZVOX Audio about additional instructions for your preferred remote control. The steps involve pressing the Volume, Mute, and Power buttons of your preferred remote control with it positioned close to the numeric display of the SoundBase. Once complete, the SoundBase will respond to these buttons from your preferred remote, in addition to the SoundBase PREPARE 1 2 Sit within easy reach of the SoundBase system’s front control panel. Locate the following buttons on your remote control: You will need to press two buttons on the SoundBase system front panel to start the learning process, then press four remote control buttons. 1 2 3 4 3 4 Press both SoundBase system VOLUME buttons until “Lrn” appears (about 4 seconds). Then release both VOLUME buttons. 3 1 2 VOLUME UP VOLUME DOWN MUTE • Get ready to press VOLUME UP on the Remote Control. POWER The learning process involves pressing these four buttons in sequence. This remote is only an example. Your remote is probably different. Please locate these buttons on your remote. If you see the “no change” message (nocH) during the learning routine, the SoundBase system system did not accept the infrared code. The current step in the learning routine will repeat. Error Message of the SoundBase Learning Routine LEARN BUTTONS volume up 1 mute volume down 2 power 3 4 When appears, press VOLUME UP for 1 second. When appears, press VOLUME DOWN for 1 second. When appears, press MUTE for 1 second. When appears,press POWER for 1 second. You should see You should see You should see You should see . . . . When appears, press VOLUME UP for 1 second, again. When appears, press VOLUME DOWN for 1 second, again. When appears, press MUTE for 1 second, again. When appears, press POWER for 1 second, again. You should see followed by You should see followed by You should see followed by You should see followed by . , . , YOU ARE DONE! . , . ,
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement