ISW-EN4204R LED Receiver Spec Sheet

ISW-EN4204R LED Receiver Spec Sheet
Intrusion Systems | Commercial Wireless ISW‑EN4204R LED Receiver
Commercial Wireless ISW‑EN4204R LED
Receiver
▶ Monitors up to four transmitters or repeaters
▶ Cost-effective solution for small systems
▶ Flexible alarm and fault output
▶ Wireless registration
▶ Compatible with a variety of transmitters and control
panels
▶ Secure wireless implementation
▶ Exclusive wireless protocol ensures maximum
performance and reliability
The ISW‑EN4204R LED Receiver integrates up to four 900
MHz wireless transmitters into any application. The
Commercial Wireless platform uses diversity reception and
advanced signal processing to reduce dead spots in
transmission areas. The LED clearly shows the current
status for each transmitter. The receiver provides versatile
options for adding high performance wireless to an
installation.
Wireless 900 MHz Band
The Commercial Wireless platform sends redundant
information on several multi-frequency channels within the
FCC Part 15 900 MHz band, providing superior range and
reliability. In comparison, systems that use a single
frequency technology can only send information on one
narrow band channel. Any interference within the band can
cause missed signals. With wireless registration, it is easy
to add this technology to any application.
System Overview
Powered by Inovonics
The Commercial Wireless platform, powered by Inovonics
wireless mesh network technology, ensures superior range,
reliability, and scalability for commercial applications.
Using a wide range of transmitters and repeaters, this
proven technology provides flexibility and performance to
meet the most stringent requirements. This exclusive
protocol is available only on Commercial Wireless products.
Functions
Flexible Outputs
Transmitters and repeater faults and alarms map to any of
the receiver models.
Wireless Registration
There is no external programmer required. The transmitter
is enrolled using a wireless programming routine built into
the receiver. Wireless registration reduces installation time.
Secure Wireless Implementation
Jam detection monitors all channels for the presence of
interference for more than 20 sec. A reset terminal is inside
the receiver, allowing the receiver to accept external reset
signals. The receiver includes case tamper and internal
antennas for added security.
www.boschsecurity.com
2 | Commercial Wireless ISW‑EN4204R LED Receiver
Status Indication
ISW-EN1249
Billtrap Transmitter
ISW‑EN1260
PIR Motion Sensor‑Transmitter (Commercial and
High‑end Domestic Applications)
Supervision and Expansion
ISW‑EN1261HT
PIR Motion Sensor‑Transmitter (High‑traffic Areas)
Transmitter supervisory check-in and a transmitter specific
supervisory window, defined in the receiver, support sites
with both removable pendants and fixed-position
transmitters. The technology also supervises repeaters.
ISW‑EN1262
PIR Motion Sensor‑Transmitter (Residential and
Low‑traffic Commercial Applications)
ISW‑EN1265
PIR Motion Sensor‑Transmitter (Ceiling‑mount
Applications)
LEDs show the current condition of each transmitter,
including activation, tamper, low battery, and inactivity.
Enroll, supervise, and map up to four wireless transmitters
and repeaters using the appropriate outputs. Configure
transmitters and repeaters individually to best suit the
application. Each includes a fifth output used for fault
reporting.
Certifications and Approvals
Parts Included
Quant.
Component
1
ISW‑EN4204R Receiver
1
Hardware pack
1
Literature – Installation and Operation Manual
Inovonics Wireless Corporation holds the following approvals:
FCC
Conforms to FCC Part 15 regulations
Technical Specifications
Electrical
Installation/Configuration Notes
Power Requirements:
Compatibility Information
Outputs
The ISW‑EN4204RLED Receiver is compatible with the
following products:
Rating:
Repeater
ISW‑EN5040‑T
Types:
High‑power Repeater
10 VDC to 14 VDC
1 A, 28 VDC, or 0.5 A, 30 VAC (resistive)
•
•
Transmitters
•
Four Form C relays for connecting to
any control panel or for stand-alone
wireless applications (NO or NC)
One NO Receiver case tamper contact
closure
One NC Receiver jam input indication
ISW‑EN1210
Universal Transmitter (Single‑input)
ISW‑EN1210EOL
Universal Transmitter with EOL Resistor
ISW-EN1210SK
Survey Transmitter
Relative Humidity:
Up to 90%, non‑condensing
ISW‑EN1210W
Door-Window Transmitter with Reed Switch
Temperature (operating):
0°C to +60°C (+32°F to +140°F)
ISW‑EN1215EOL
Universal Transmitter with Wall Tamper and EOL
Resistor
Mechanical
ISW‑EN1215WEOL
Door‑Window Transmitter with Wall Tamper, Reed
Switch, and EOL Resistor
ISW‑EN1223D
Water-resistant Pendant Transmitter
(Double-button)
ISW‑EN1223S
Water-resistant Pendant Transmitter
(Single-button)
ISW‑EN1223SK
Survey Pendant Transmitter
Reception Characteristics
ISW‑EN1233D
Necklace Pendant Transmitter (Double‑button)
ISW‑EN1233S
Necklace Pendant Transmitter (Single‑button)
ISW‑EN1235D
Beltclip Pendant Transmitter (Double‑button)
ISW‑EN1235S
Beltclip Pendant Transmitter (Single‑button)
ISW‑ EN1235DF
Fixed-location Transmitter (Double‑button)
ISW‑ EN1235SF
Fixed-location Transmitter (Double‑button)
ISW‑EN1242
Smoke Detector-Transmitter
ISW‑EN1247
Glass-break Sensor Transmitter
Environmental
Material:
ABS
Closure:
Latching with optional screws for high
security installations
Dimensions:
16.5 cm x 8.9 cm x 2.5 cm
(6.5 in. x 3.5 in. x 1 in.)
Weight:
204 g (7.2 oz)
Frequency Compatibility:
902 MHz to 928 MHz
Transmitters:
Supports up to four
Commercial Wireless ISW‑EN4204R LED Receiver | 3
Trademarks
Trademark names are used throughout this document. In
most cases, these designations are claimed as trademarks
or registered trademarks in one or more countries by their
respective owners. Rather than placing a trademark symbol
in every occurrence of a trademark name, Bosch Security
Systems, Inc. uses the names only in an editorial fashion
and to the benefit of the trademark owner with no intention
of infringing the trademark.
Inovonics is a trademark of Inovonics Wireless Corporation.
Ordering Information
Commercial Wireless ISW‑EN4204R LED
Receiver
Monitors up to four wireless transmitters or
repeaters
ISW-EN4204R
www.boschsecurity.com
4 | Commercial Wireless ISW‑EN4204R LED Receiver
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
[email protected]
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
[email protected]
www.boschsecurity.com
© Bosch Security Systems Inc. 2009 | Data subject to change without notice
T6054624267 | Cur: en-US, V1, 30 Jun 2009
Asia-Pacific:
Represented by
Robert Bosch (SEA) Pte Ltd, Security Systems
38C Jalan Pemimpin
Singapore 577180
Phone: +65 6319 3453
Fax: +65 6319 3499
[email protected]
www.boschsecurity.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement