UltraView KTP Power Supply Series (KTP-24

UltraView KTP Power Supply Series (KTP-24
KTP-24-8 Multiple Output Power Supply
The KTP-24-8 is a compact and durable power supply that is typically used to power up to eight CyberDomes. It features
eight isolated 24 VAC outputs that can power devices requiring 1 amp or less. Each output is equipped with a resettable
fuse. The unit can be powered from either a standard 115 or 230 VAC source. A rack-mount accessory is available.
Note: The KTP-24-8E4 can be used as a standard 230 VAC source.
CAUTION:
The KTP-24-8 was designed for indoor applications only. For outdoor units with a heater and fan, use the KTP-24 or KTP24C.
INSTALLING THE UNIT
1)
Mount the unit using the slots provided.
2)
Make cable connections to the KTP-24-8 as shown in Figure 1. Refer to Table 1, “Maximum Cable Length,” for
suitable cable gauge sizes when connecting the output cables.
Figure 1.
KTP-24-8 cable connections
1045073B / November 2003
Technical Support: 800-469-1676
1
KTP-24-8 Multiple Output Power Supply
Installation Instructions
OPERATION
Table 1. Maximum cable length
Each 24 VAC output of the power supply has a resettable fuse that will trip
if the current draw exceeds one amp. In this event, the device on that
output may operate intermittently, or not at all. The fuse will automatically
reset itself when the load is removed from the output.
CAUTION:
Do not reconnect any device that caused an output fuse to trip until
the device has been inspected and determined to be in proper
working condition.
2
© 2003 GE Interlogix
Maximum Cable Length
All Domes
Wire Gauge
without Heater/Fan
(20VA)
10
2.60
3000
915
12
2.05
1900
580
14
1.62
1200
365
16
1.29
750
230
18
1.02
465
142
20
0.81
290
90
22
0.64
185
56
1045073B / November 2003
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement